Wiring The Nx-582; Nx-582 Layout; Terminal Description - CADDX NX-582 Manual

WIRING THE NX-582

Wire the 3-position terminal on the NX-582 to the NX-8 control panel keypad
interface as follows: Positive to KP POS, COM to KP COM, and DATA to KP DATA.
Connect the wiring harness from the NX-582 connector labeled J6 to the AES
radio connector labeled J1. Refer to connection diagram.

NX-582 LAYOUT

TERMINAL DESCRIPTION

Table 1.1
POS Connect to the KP POS terminal of the NX-8. Current draw is 30
mA for the NX-582.
COM Connect to the KP COM terminal of the NX-8.
DATA Connect to the KP DATA terminal of the NX-8.
J6 Connect to the cable of the AES radio.
4