Spine Centering Parts; Installing The Holding Down Device; Adjusting The Holding Down Device - Hohner ST 55 L Operating Instructions/Spare Parts List

3.6 Spine centering parts

The centering parts are only used for saddle stitching. They serve to precisely position the staple
in the fold centre of the sheets

3.6.1 Installing the holding down device

- Fig. 16 -
- In order to install the holding down device
and tighten the fastening screw

3.6.2 Adjusting the holding down device

- Fig. 16 -
The centering prism
- Move the centering prism
slider .
- Adjust the height of the prism
and tighten the fastening screw
Hohner Maschinenbau GmbH
(- cf. 15 -)
, insert the guide pin into the borehole on the bender
.
can be moved back and forth by turning the adjusting screw
backward or forward until it is precisely aligned with the prism of the
(approx. 0.5 mm above the clincher box) by moving it in the slot
.
ST 55 L
Operation
.
31