Fitting The Clincher Box - Hohner ST 55 L Operating Instructions/Spare Parts List

3.1.3 Fitting the clincher box

- Fig. 6 -
The centre of the bender inside the stitching head must be precisely aligned to the centre of the
clincher box.
- Loosen the clamping screws
- Move clincher box until it is precisely aligned with the centre of the bender.
- Fasten clincher box by tightening the clamping screws.
Using the clincher box setting gauge
- Fig. 7 -
- Remove former (see page 35).
- Place gauge on former locating pin
can be exactly aligned in this position when the gauge is aligned with the scale marks on the
clincher box.
- Tighten clamping screws
- Refit former.
Hohner Maschinenbau GmbH
.
and turn downward against stopper. The clincher box
and remove gauge .
ST 55 L
Operation
19