Table of Contents
Advertisement
3.1 Installation of the stitching head
3.1.1 Clamping the stitching head
- Fig. 4 -
The stitching head is held by a tenon block which is inserted into the stitching head mounting on
the machine.
- Loosen tenon block
- Insert the stitching head with tenon block (top tilted to the front) in the stitching head mounting
The two ball bearings
- Fix stitching head in stitching head mounting by tightening the tenon block
The stitching unit is equipped with a basic mounting position. The stitching head with its slides and
the ball bearings
is fastened in the basic mounting position with a mounting pin
- The mounting pin
before the stitching head is put into operation. Preserve the mounting pin carefully.
- Lead the mounting pin
the basic mounting position before removing the stitching head.
3.1.1.1 Lateral adjustment of the stitching head
- Fig. 4 -
The center of the wire formed parts within the stitching head must be set to the desired stitching
position for the wire stitch by lateral adjustment.
- Loosen the tenon block
- Move the stitching head sideways, until the desired position is reached.
- Fix the tenon block in the stitching head mounting
Hohner Maschinenbau GmbH
with Allen key SW4
on the stitching head must be located in the guides of the lifting bar.
should only be used for assembly and disassembly and must be removed
through the stitching head housing and the two slides in order to fasten
with the Allen key
. Unscrew the screw as far as possible.
.
with the Allen key.
ST 55 L
Operation
with the Allen key.
.
15
Advertisement
Table of Contents
