Advertisement
ASSEMBLY OF THE EASTWOOD LIGHTING
SYSTEM ACCESSORIES
#32401 EASTWOOD UNDERHOOD LIGHT BRACKET
Consists of:
(2) Halves of Bracket
(1) Sliding Light Module Mount
(2) Thumb Screws
ASSEMBLING THE # 32401 EASTWOOD
UNDERHOOD LIGHT BRACKET.
• Insert the rail on the rear of the sliding Light
Module Mount into the channel of one half
of the Underhood Bracket while simultane-
ously depressing spring-loaded buttons of
the Light Module Mount (FIG 6).
• Align the Rubber Covered Hooks and
channels of the Underhood Bracket so
that they are facing the same direction
then slip the open half over the male
connector block (FIG 7).
• Using two included Thumb Screws,
secure the two halves together (FIG 8).
• Adjust as required.
6
Eastwood Technical Assistance: 800.343.9353 >> techelp@eastwood.com
FIG. 6
FIG. 7
FIG. 8
Advertisement
