Advertisement
OPERATION
• Grip the Handle/Stand and rotate Lamp
through 130° to support or mount lamp
magnetically. NOTE: The Handle/Stand
design allows for quick attachment on the
separately available #32401 Eastwood
Underhood Bracket (not included) or the
#32402 Eastwood Light Tripod
(not included).
• Depress and release round Switch located at rear of housing once for Full Brightness and
a 2nd time for Off (FIG 1).
• Depress and hold Switch in for 3 seconds (lamp will blink twice) to gradually dim lamp
(will blink twice again when dimmest setting is reached).
• Depress and release again to turn Off, depress and hold to resume full brightness.
NOTE: Default setting is Full Brightness. Switching Off and On quickly at any time will
return Lamp to Full Brightness.
CHARGING
• When the Lamp fails to illuminate and/or
the 4 Tri-Color (Green, Amber & Red) LED
charge level segments at the rear of the
Housing do not illuminate, a charge is re-
quired. Note that the number of illuminated
LED's will decrease in number from four to
one as the charge depletes.
- Flip up rubber seal and plug the round
terminal of included Wall Charger or 12 Volt Power Port Cable into rear of Housing (FIG 2).
- Plug wall unit into properly grounded 120 VAC, 60 Hz. outlet
- Allow 3 hours for full charge.
- The array of 4 Green, Amber and Red LED's at the rear of the Housing will all illuminate
to indicate full charge (FIG 2).
- Close Charging Port Cover to maintain IP-65 rating.
4
Eastwood Technical Assistance: 800.343.9353 >> techelp@eastwood.com
FIG. 1
FIG. 2
Advertisement
