Advertisement
Quick Links
Installation Instructions for
MonoPoint 4" Round, Surface, & Rectangular Canopy
KABLE LITE MONOPOINT CANOPIES
GENERAL PRODUCT INFORMATION:
This product is suitable for indoor dry locations only.
This product can be dimmed with a standard incandescent
dimmer.
Minimum volume of the electrical box must be 6 cubic
inches (98 cubic centimeter).
Shaping the Hard Wires
1A
Bend the hard wires to desired shape with hands.
1
1
1
Resizing the Hard Wires
2A
HARD WIRE
NOTE: To avoid electrical shorts, do not remove the
clear insulator.
1
If necessary cut the hard wires and the clear insulators to
the desired length with a sharp cutter.
Cut 1/4" of the clear insulators on the hard wire, where
2
the fixture is going to be connected, with a sharp knife.
920KLCNPY
700KC_
2
1
INSULATOR
1.7
Advertisement
Summary of Contents for Tech Lighting MonoPoint 4
- Page 1 920KLCNPY Installation Instructions for MonoPoint 4" Round, Surface, & Rectangular Canopy 700KC_ KABLE LITE MONOPOINT CANOPIES GENERAL PRODUCT INFORMATION: This product is suitable for indoor dry locations only. This product can be dimmed with a standard incandescent dimmer. Minimum volume of the electrical box must be 6 cubic inches (98 cubic centimeter).
- Page 2 Installing the Rectangular Canopy Installing the 4" Round Canopy 120 VOLT #6-32 SCREWS 120 VOLT ELECTRICAL BOX POWER WIRES POWER WIRES 12 VOLT TRANSFORMER WIRES CEILING 4" ROUND CANOPY LONG #8-32 WALL 12 VOLT ROUND HEAD TRANSFORMER RECTANGULAR SCREW WIRES CANOPY Turn the power to the electrical box off.
- Page 3 Connecting the Fixture Installing the Surface Canopy 120 VOLT POWER LINE WIRES ELECTRICAL #4-40 SET SCREW BACK PLATE 0.05 ALLEN WRENCH #8-32 ROUND CEILING HEAD SCREW 120 VOLT TRANSFORMER WIRES DOME COVER #4-40 SCREW Turn the power to the electrical box off. Connect the fixture on the hard wires (refer to the instructions provided with the fixture).
- Page 4 7400 Linder Ave, Skokie, IL 60077 847.410.4400 www.techlighting.com © 2008 Tech Lighting, L.L.C. All rights reserved. The "Tech Lighting" graphic is a registered trademark of Tech Lighting, L.L.C. Tech Lighting reserves the right to change specifications for product improvements without notification.