Tech Lighting Vance 700FMVNC13 Installation Instructions

Installation Instructions for
Vance and Lance 13 Flush Mount
CEILING COLLECTION
G ENERAL RODUCT NFORMATION P I
These fixtures are intended to be installed
utilizing NEC compliant junction boxes.
This product is suitable for damp locations.
This product can be dimmed with a low-voltage electronic
dimmer.
This instruction shows a typical installation.
Install the fixture
1A
2
1
Ground the fixture in accordance with local electrical
codes.
2
Connect the black fixture wire to the hot power line
wire with a wire nut.
3 Connect the white fixture wire to the neutral power line
wire with a wire nut.
:
1
FIXTURE
BASE
3
700FMVNC13, 700FMLNC13
CAUTION RISK OF FIRE
This product must be installed in accordance with
the applicable installation code by a person familiar
with the construction and operation of the product
and the hazards involved.
Use minimum 90°c supply conductors.
1B 1B
2 4
#8-32
SCREW
5
Note: depending on the dimensions of the J-box, you
may use either the inner or outer through holes.
Align the through holes in the fixture base with the #8-
4
32 screws to junction box.
3 5 Firmly tighten the #8-32 screws to hold the fixture base
in place through the next steps.
1
920FMVANLANS
-
FIXTURE
BASE
5
1.0