FCC RF Radiation Exposure Statement:
1. This Transmitter must not be co-located or operating in conjunction with any
other antenna or transmitter.
2. This equipment complies with RF radiation exposure limits set forth for an
uncontrolled environment. This equipment should be installed and operated
with a minimum distance of 0.5 cm between the radiator and your body.
Warning: the AC adaptor is used as disconnect device and it should remain readily
operable during intended use. In order to disconnect the mains plug from mains
completely, the AC adaptor should be disconnected from the mains socket outlet
completely. The socket-outlet shall be installed near the equipment and shall be
easily accessible.
Warning
• High or low extreme temperatures that a battery can be subjected to during use,
storage transportation, and low air pressure at high altitude.
• Replacement of a battery with an incorrect type that can defeat a safeguard (for
example, in the case of some lithium battery types).
• Disposal of a battery into fire or a hot oven, or mechanically crushing or cutting
of a battery, that can result in an explosion.
• Leaving a battery in an extremely high temperature surrounding environment that
can result in an explosion of the leakage of flammable liquid or gas.
• A battery subjected to extremely low air pressure that may result in an explosion
or the leakage of flammable liquid or gas.
3
Need help?
Do you have a question about the 100002435 and is the answer not in the manual?
Questions and answers
My notebook does not turn on
Your Onn notebook (part number 100002435) may not be turning on due to one of the following reasons:
1. Battery Issues: If the battery was fully drained, it might take a few minutes before the device can be powered on. Charging from 0% to 70% takes approximately 1.5 hours.
2. Over-Discharge Protection Mode: If the device has not been used for a long time, the battery might be in over-discharge protection mode, requiring a longer charging time before it can turn on.
3. UEFI Settings Change: If you recently changed the "Operating System" setting in the UEFI setup, the device may no longer boot properly, leading to a black screen.
4. Firmware or NVRAM Issue: If attempts were made to reset the NVRAM, but the device still only shows a black screen, the firmware might be corrupted.
To troubleshoot, try charging the device for at least 1.5 hours, resetting the UEFI settings (if possible), or seeking support for repair or replacement.
This answer is automatically generated
Our laptop 1766620 Onn-100002435 will NOT come on?
The Onn laptop model 100002435 may not turn on due to the following reasons:
1. Battery Over Discharge Protection Mode – If the laptop has not been used for a long time, the battery may be in over-discharge protection mode, requiring more time to charge before it can power on.
2. Fully Drained Battery – If the battery was completely drained, it may take a few minutes of charging before the laptop can be turned on.
3. Incorrect OS Selection in Firmware – Changing the OS selection setting in the Aptio Setup Utility to an unsupported option (e.g., Linux) may cause the device to become unresponsive.
To troubleshoot, ensure the laptop is charging properly, wait for sufficient charging time, and check the firmware settings if needed.
This answer is automatically generated
will not charge, flashing only never green. can battery be replace