Safety Recommendations - Cisco WS-X3011 Configuration Note

Safety Recommendations

Figure 1
FLE X SLO T
The specifications of the router card are listed in Table 1.
Table 1
Description
Processor
Memory
NVRAM
Flash
Interfaces
Safety
EMI
1
2
3
Safety Recommendations
Follow these guidelines to ensure general safety:
•
•
•
•
•
2 Router Card (WS-X3011) Configuration Note
Model WS-X3011 Router Interface Card
BRI 0
ETH 0
SERIAL 0
SERIAL 0
SERIAL 1
DIAG
BRI 0
Router Card Specifications
IEEE = Institute of Electrical and Electronic Engineers.
The synchronous serial interface supports the following standards in data terminal equipment (DTE)
and data communications equipment (DCE) mode: EIA/TIA-232, EIA/TIA-449, V.35, and X.21. The
EIA-530 standard is supported in DTE mode only.
External network terminal 1 (NT1) device required.
Keep the chassis area clear and dust-free during and after installation.
Keep tools away from walk areas where you and others could fall over them.
Do not wear loose clothing that could get caught in the chassis. Fasten your tie or scarf and roll
up your sleeves.
Wear safety glasses if you are working under any conditions that might be hazardous to your
eyes.
Do not perform any action that creates a potential hazard to people or makes the equipment
unsafe.
SERIAL 1
AUX
Specification
20-MHz Motorola 68EC030
8-MB (minimum) dynamic random-access memory
(DRAM) for main memory and shared memory
32-KB nonvolatile random-access memory (NVRAM)
for storing configuration information
8-MB (minimum) flash memory for running the
Cisco IOS software
1
1 Ethernet (IEEE 802.3) (Internal)
2
2 Synchronous serial (DB-60)
3
1 ISDN BRI (RJ-45)
UL 1950, CSA 22.2-No. 950, Austel TS001,
EN 60950, IEC 950
FCC Part 15 Class A, VCCI Class II, CISPR 22B,
EN 55022 Class B, CE Marking, Canadian ICES-003
Class A
WS-X30 11