Advertisement
Quick Links
®
Ezy-Wash
Food Service Tapware
PRODUCT CODES:
- TF78WC-ESS
SPECIFICATIONS
The Galvin Specialised Ezy-Wash
The wall mounted hot and cold lever mixer features a polished chrome plated body for optimum stability.
This Ezy-Wash
®
product is laminar flow (not aerated).
Our highly sought after lever handle design is easily operated with elbows, wrists or hands.
Quick action SBA's include a brass jumper valve component, with red and blue indicator buttons on 150mm
lever action handles.
This unit is supplied with a wall mounted stainless steel cable to provide strength to the spout when using
the hook for bucket filling.
IMPORTANT: All Ezy-Wash
good working order.
TECHNICAL DATA
Inlet
Outlet
Headwork
Working Pressure Range (kPa)
Working Temperature Range (°C)
Nominal Flow Rate (LPM)
Finish
NOTE: Galvin Specialised continually strive to improve their products. Specifications may change without notice.
TOOLS REQUIRED
Power drill, Spanner & Hex Key
Thread tape or Sealant.
®
product range is used for hand sinks, bar sinks and more.
®
product taps are tested in accordance with AS/NZS 3718 and leave our premises in
½" BSP – Female
Laminar Flow
Jumper Valve
Min
50
Max
500
Min
5
Max
80
7.5
Chrome
Advertisement
Subscribe to Our Youtube Channel
Related Manuals for Galvin Specialised Ezy-Wash TF78WC-ESS
Summary of Contents for Galvin Specialised Ezy-Wash TF78WC-ESS
- Page 1 Working Pressure Range (kPa) Working Temperature Range (°C) Nominal Flow Rate (LPM) Finish Chrome NOTE: Galvin Specialised continually strive to improve their products. Specifications may change without notice. TOOLS REQUIRED Power drill, Spanner & Hex Key Thread tape or Sealant.
- Page 2 1300 514 074 INSTALLATION IMPORTANT: Galvin Specialised products must be installed in accordance with these installation instructions and in accordance with AS/NZS 3500, the PCA and your local regulatory requirements. Water and/or electrical supply conditions must also comply to the applicable national and/or state standards. Failing to comply with these provisions shall void the product warranty and may affect the performance of the product.
- Page 3 3. Fit grub screws 4. Fit bracket Ensure the body is pushed firmly against the tail and With the supplied screws, secure the top and then secure in place with the supplied grub screws. lower halves of the bracket to the spout ...
- Page 4 TROUBLESHOOTING PROBLEM CAUSE RECTIFICATION Jumper valves are worn or damaged Replace jumper valve Taps are dripping water Tap seat is damaged Refurbish tap seat using a reseating tool. Water is leaking O-ring on jumper valve spindle Replace o-ring from spindle is damaged or worn Water is turned off Turn water on...
Need help?
Do you have a question about the Ezy-Wash TF78WC-ESS and is the answer not in the manual?
Questions and answers