Advertisement
2.
Installing the KRK-13 (Dual Control Head) to the Transceiver
2-1. Remove the Display Unit from the transceiver
Step 1: Lift the two tabs of the panel on the bottom of
transceiver with a flat-head screwdriver ①
and remove the panel from the chassis ② as
shown in Figure 2-1-1.
Note: Confirm that the tabs of the speaker hardware
fixture and holder are securely fitted in the Display
Unit.
Step 2: Remove the flat cable from the connector
(CN901) of the display unit of the panel ③.
Step 3: Smooth out the flat cable, and fold it as
shown in Figure 2-1-2. ④,⑤,⑥.
2-2. Install the Dual Mobile Head Adapter onto the transceiver
Step 4: Insert the flat cable that was removed in step 2 above into the connector (J3) of the
interface unit of the Dual Mobile Head Adapter
⑦.
Note: The terminal side of the flat cable must face down
towards the PCB when inserting the flat cable into the
connector.
Step 5: Fit the Dual Mobile Head Adapter with four tabs
onto the front of the chassis ⑧ as shown in
Figure 2-2.
Note: When installing the Dual Mobile Head Adapter onto
the front of the chassis, hold down the flat cable with
your fingers to prevent it from being caught.
Fig. 2-1-1
Fig. 2-1-2
Fig. 2-2
2
Advertisement
