NREZ021
■ C H A R A C T E R I S T I C S
1. A n a l o g u e & d i g i t a l t i m e d i s p l a y s : Hour,
Minute, Second, Month, Date and Day of the
week.
2. Daily alar m and hourly chime: The alarm
can be set to sound at the designated time
on a 24-hour basis and the chime can be set
to sound every hour on the hour with a single
beep.
3. S t o p wa t c h : T h e s t o p wa t c h c a n m e a s u r e
up to 23 hour s 59 minutes and 59 seconds
i n 1 / 1 0 0 - s e c o n d i n c r e m e n t s . S p l i t t i m e
measurement is available.
4. Selection of 12 or 24-hour format: The time
display format in either 12-hour indication or
24-hour indication can be selected.
5. EL backlight: The built-in electro-luminescent
(EL) backlight illuminates the display for easy
viewing in darkness.
■ D I S P L AY A N D B U T T O N F U N C T I O N
DAY O F W E E K
S 4 ( L I G H T )
S 3 ( M O D E )
H O U R S
M I N U T E S
■ S E T T I N G T H E T I M E ( A N A L O G U E )
1. Pull the crown out one step, the second hand
will stop.
2. Set the correct time by turning the crown.
3. Push the crown back to the original position.
The watch will start running again.
* The analogue indication and digital display of
the time setting can be adjusted separately.
■ H O W T O S E T T I M E / C A L E N DA R
1. From NORMAL TIME mode, press S3 button
three times to begin setting procedure.
The second digits start flashing.
2. Press S1 button to reset the second digits to
zero.
*
If S1 button is pressed when the second digits
are in a range between 30 and 59, the second
digits will be reset to 00 and one minute will be
added. If S1 button is pressed when the second
digits are in a range between 00 and 29, the
second digits will be reset to 00 and the minute
digits will be unchanged.
3. Press S2 button to move on to HOURS setting.
*
Selection of the digits to be adjusted is made in
the following order by pressing S2 button. Press
S1 button to adjust the value.
*
When setting HOURS, "H" stands for 24-hour
format, "A" or "P" stands for 12-hour format.
SECONDS
S 2
S 2
DAY OF
S 2
THE WEEK
4. Press S3 button after completing the setting.
3 t i m e s
NORMAL TIME
S 3
DAY OF WEEK SETTING
BY PRESSING S1
S 2
DATE SETTING BY
PRESSING S1
S 2
3-2013
CAL. Z021 (RW6 SERIES)
M O N T H
DAT E
S 1 ( S TA R T / S TO P )
C H I M E
A L A R M
S 2 ( R E S E T )
S E C O N D S
C R OW N
HOURS
MINUTES
S 2
12/24H-
FORMAT
S 2
MONTH
DATE
P R E S S
S 3
SECONDS SETTING
BY PRESSING S1
S 2
S 2
HOURS SETTING BY
PRESSING S1
S 2
MINUTES SETTING BY
PRESSING S1
S 2
MONTH SETTING BY
PRESSING S1
■ H O W T O C H A N G E T H E D I S P L AY
M O D E
*
Press S3 button to show the NORMAL TIME
mode.
*
If the NORMAL TIME mode is shown already on
the display, skip the above operation.
*
Press S3 button to change the display mode in
the following order.
NORMAL TIME mode
S 3
TIME SETTING mode
■ H O W T O S E T A L A R M T I M E
1. From NORMAL TIME mode, press S3 button
twice to enter the ALARM mode.
2. Press S2 button to begin setting procedure.
The hours digit starts flashing.
3. Press S1 button to set HOURS setting.
4. Press S2 button to move on to MINUTES setting.
Press S1 button to set MINUTES setting.
5. Press S2 button to confirm the settings.
6. Press S3 button to retur n to NORMAL TIME
mode.
NORMAL TIME mode
S 3
S 2 for confir mation
MINUTES SETTING BY
PRESSING S1
Engagement/Disengagement of ALARM &
CHIME
*
In the ALARM setting mode, with each press
of S1 button, the ALARM and CHIME can be
engaged or disengaged in the following order.
The ALARM signal and/or CHIME signal appear
or disappear on the display accordingly.
S 2
NORMAL TIME
S 3
ALARM/CHIME ON
How to stop the alarm sound
Press S1 or S2 to stop the alarm while it is sounding.
Snooze function
Press S3 to tur n the snooze function on or off
alternately. When the snooze function is enabled,
the alar m will stop sounding temporar ily and
go off again 5 minutes later for 20 seconds and
automatically stop.
STOPWATCH mode
S 3
S 3
ALARM mode
S 3
ALARM mode
P R E S S
S 3
t w i c e
S 2
S 2
HOURS SETTING BY
PRESSING S1
P R E S S
S 3
t w i c e
ALARM MODE
S 1
ALARM ON
S 1
S 1
CHIME ON
Need help?
Do you have a question about the RW6 Series and is the answer not in the manual?
Questions and answers