Page 1
BEVERAGE CENTER Use & Care Guide For questions about features, operation/performance, parts or service, call: 1-800-253-1301 In Canada, call for assistance 1-800-807-6777 or visit our website at... www.whirlpool.com or www.whirlpool.ca W11176204 - 8336460163100...
BEVERAGE CENTER SAFETY Your safety and the safety of others are very important. We have provided many important safety messages in this manual and on your appliance. Always read and obey all safety messages. This is the safety alert symbol. This symbol alerts you to potential hazards that can kill or hurt you and others.
INSTALLATION INSTRUCTIONS Location Requirements 14.3/4” (37.5 cm) 34.3/8” (87.3 cm) min. 35” (88.9 cm) max. 1/2” Explosion Hazard (1.3 cm) Keep flammable materials and vapors such as gasoline away from Beverage Center. Failure to do so can result in death, explosion, 24”...
Unpack the Beverage Center Reverse Door Swing (optional) Tools Needed: Phillips screwdriver and an 8 mm wrench (or 5/16” in wrench). Excessive Weight Hazard 1. Unplug Beverage Center or disconnect power. Use two or more people to move and install Beverage Center.
8. Pull out the kickplate and set aside. 15. Fasten the top hinge with three silver screws and move the remaining four screws to the opposite side. 9. With the wrench, remove the screws (A) fastening the Completely tighten all seven screws. bottom hinge (B) to the Beverage Center cabinet and set aside.
NOTE: Having someone push against the top of the Beverage Center takes some weight off the leveling legs. Base Grille This makes it easier to adjust the leveling legs. Tools Needed: Phillips screwdriver Remove the Base Grille 1. Open the Beverage Center door. 2.
Adjusting the Controls There are three temperature control set points for this model: For your convenience, your control is preset at the Beverage Center Upper Lower default temperature. setting Compartment cCompartment Cold 33 °F (1 °C) 42 °F (6 °C) •...
To Stock the Beverage Center: NOTE: The wine rack can be stocked with the bottles facing either direction, however, to optimize storage 1. Place juices, sodas or other canned beverages on the adjacent bottles should be facing in opposite directions. glass shelves.
6. Clean the condenser coils regularly. They are located behind the base grille. Coils may need to be cleaned as Vacation and Moving Care often as every other month. This may help save energy. • Remove the base grille. See “Base Grille”. Vacation •...
Page 11
run longer in order to cool the Beverage Center back • Is the gasket dirty or sticky? Clean the gasket and the down. surface that it touches. Rub a thin coat of paraffin wax on the gasket following cleaning. • Is the door opened often? Expect the motor to run longer when this occurs.
Canada. In the U.S.A. For Further Assistance If you need further assistance, you can write to Whirlpool Call the Whirlpool Customer eXperience Center toll free: Canada with any questions or concerns at: 1-800-253-1301.
Care Guide, scan the QR code on the right to access additional resources, or visit www.whirlpool.com/product_help. 2. All warranty service is provided exclusively by our authorized Whirlpool Service Providers. In the U.S. and Canada, direct all requests for warranty service to: Whirlpool Customer eXperience Center.
Page 14
7. Damage from accident, misuse, abuse, fire, floods, acts of God or use with products not approved by Whirlpool. 8. Repairs to parts or systems to correct product damage or defects caused by unauthorized service, alteration or modification of the appliance.