impro XTT901 Installation Manual page 6

Figure 2: Electrical Conduit Blanking Plate Options
The Impro CA is approved for use with the following Electrical Conduit Blanking Plates
(specific to the European Market):
Jung LS994B.
•
Jung CD500.
•
Merten ARTEC.
•
Gira System 55.
•
Housing the Impro CA
1. Drill a 5 mm hole in the centre of your chosen Electrical Conduit Blanking Plate, to
accommodate the Status LED.
2. Remove the paper covering from the double-sided adhesive tape.
NOTE: Place general purpose Silicone Sealer around the base of the Status LED
for added waterproofing.
3. Push the Status LED through the hole, in the Blanking Plate, from back to front.
4. Firmly press the Impro CA to the back of the Electrical Conduit Blanking Plate.
XTT301-0-0-GB-20
Blank Space
March 2019 Page 6