Serial Number Label; Guarantee Or Warranty - impro XTT901 Installation Manual

NOTE: On powering up, the Antenna Reader's Status LED will illuminate solid Red.
The Antenna Reader will not read Tags until configured in the Software.

Serial Number Label

1. Once the Antenna Reader is installed, sketch a rough site plan.
2. Attach the Antenna Reader's loose Serial Number Label and the Controller,
Terminal or Receiver's Fixed Address Label, to the sketched site plan in the
position of the Antenna Reader.
The Antenna Reader does not have its own Fixed Address. When connected to a
Controller, Terminal or Receiver the Antenna Reader is assigned one of the available
Fixed Addresses.
The Serial Number Label identifies the type of Antenna Reader, and the Fixed Address
Label (shipped with the Controller, Terminal or Receiver) identifies the Fixed
Addresses. Both these labels should be attached to the site plan to assist in identifying
the hardware once an Auto-ID is performed.

GUARANTEE OR WARRANTY

This product conforms to our Guarantee or Warranty details placed on our Web Site, to
read further please go to www.impro.net.
This manual applies to the Impro 125 kHz Antenna Readers,
HRL900-1-0-GB-XX, HRL901-1-0-GB-XX, HRL902-1-0-GB-XX, XTT901-1-0-GB-00,
XTT902-1-0-GB-01, XTT903-1-0-GB-00, XTT904-1-0-GB-03,
XTT905-1-0-GB-01, XTT906-1-0-GB-00, XTT907-1-0-GB-01,
XTT908-1-0-GB-01, XTT909-1-0-GB-00, XTT950-1-0-GB-01,
HRL905-1-0-GB-XX, XTT951-1-0-GB-02, HRL903-1-0-GB-XX,
XTT952-1-0-GB-02, HRL904-1-0-GB-XX and HRL906-1-0-GB-XX.
(The last two digits of the Impro stock code indicate the issue status of the product).
XTT301-0-0-GB-20
XTT301-0-0-GB-20
March
Issue 21
2019
March 2019
Impro Antenna Readers\English Manuals\ LATEST
ISSUE\AntRdrs-insm-en-20.docx
Page 12