Install Remote Control Battery - Philips CEM250/93 User Manual

5
Install the sleeve into the dashboard and
bend the tabs outward to fi x the sleeve.
Note
•
Skip this step if the unit is not fi xed by sleeve but by
supplied screws.
6
Place the supplied rubber cushion over the
end of the mounting bolt.
7
Slide the unit into the dashboard until you
hear a click sound.
8
Reconnect the negative terminal of the car
battery.
12 EN
Attach the front panel
1
Attach the trim plate.
2
Insert the right side of the panel in the
chassis until it is correctly engaged.
3
Press the left side of the panel and point
the left hole at the left pillar.
4
Release the panel to engage the left side.

Install remote control battery

Caution
•
Risk of explosion! Keep batteries away from heat,
sunshine or fi re. Never discard batteries in fi re.
•
Risk of decreased battery life! Never mix different brands
or types of batteries.
•
Risk of product damage! When the remote control is not
used for long periods, remove the batteries.
•
Perchlorate Material - special handling may apply. See
www.dtsc.ca.gov/hazardouswaste/perchlorate.