IBM 5251 Series Maintenance Information Manual page 134

1-116
HHHHHHHHHH HHHHHHH HHHHHHH HHHHHHH HHHHHHHHHH HHHHHHH HHHHHHH HHHHHHH HHHHHHHHHH
H DISPLAY ATTRIBUTES XX--XX H
H ENTER C TO RETURN TO DISPLAY VERIFICATION MENU: H
H H
~ ~~~r:kE'
iMAGE::::::::
~ :~f:::
:
'~!~ll?ri
*******************************
~
H HIGH INTENSITy •••.••• X'22' •.. ABCDE
*
ABCDEFGHIJKLMNOPQRSTUVWXYZ
*
H
H UNDERSCORE .•••••••••. X'24' ... ABCDE * x.(+&*);-/,%->?:'="I * H
H NONDISPLAY ........... X' 27' ... - - HH
*
0;23456789 01234567B9
*
H
H BL INK. • • • • . • • • • • . . • •• X
I
28
I • • •
ABCDE HH
*******************************
H
H COLUMN SEPARATOR ••.•• X' 30' •••
IJlIi?jdltl
HH H
HHHHHHHHHH HHHHHHH HHHHHHH HHHHHHH HHHHHHHHHH HHHHHHH HHHHHHH HHHHHHH HHHHHHHHHH
HHHHHHHHHH HHHHHHH HHHHHHH HHHHHHH HHHHHHHHHH HHHHHHH HHHHHHH HHHHHHH HHHHHHHHHH
H HH H
H
HH
H
H HH H
H HH H
H HH H
H
HH
H
H HH H
H HH H
H HH H
H HH H
HHHHHHHHHH HHHHHHH HHHHHHH HHHHHHH HHHHHHHHHH HHHHHHH HHHHHHH HHHHHHH HHHHHHHHHH
Select the display attributes option by:
xx---xx
(station ID) can be up to 10 characters.
1. Pressing the 1 key.
2. Pressing the Enter key.
This display tests the attributes, the Contrast control,
and the alignment of characters on the display screen.
How to use this display:
1. Turn the Contrast control fully clockwise and
slowly decrease the Brightness control; observe
the pattern of H's that alternate in intensity.
2. Adjust the Brightness control to obtain the best
character image.
3. Press the Spacebar once to position the cursor on
the right side of the display screen.
4. Key in one of the hexadecimal numbers shown on
the left side of the display screen; press the Enter
key. Observe the results that take place on the
right side of the display screen. Compare these
results with the attribute description on the left: A
wrong entry causes the entry to blink at high
intensity. Repeat steps 3 and 4 for each of the
remaining hexadecimal numbers.
Note: Attribute combinations are not shown on this
display screen. Refer to 202 Attribute Characters for
these combinations.
Return to the Display Verification Menu by:
1. Pressing the C key.
2. Pressing the Enter key.
206