Troubleshooting - Philips CED320/51 User Manual

9 Troubleshooting

Warning
•
Never remove the casing of this apparatus.
To keep the warranty valid, never try to repair
the system yourself.
If you encounter problems when using this
apparatus, check the following points before
requesting service. If the problem remains
unsolved, go to the Philips web site (www.
philips.com/welcome). When you contact
Philips, ensure that the apparatus is nearby
and the model number and serial number are
available.
No power
• Car engine has not been started. Start
the car engine.
• Connections is incorrect.
• Fuse has been damaged.
'Replace fuse' on page 33).
No sound
• Volume is too low. Adjust volume.
• Speaker connections is incorrect.
No response to the remote control
• Ensure that the path between the
remote control and the unit iis clear from
obstacles.
• From a close distance, point the remote
control directly at the unit.
• Replace the remote control battery .
• The function does not work. Refer to the
instructions.
Disc does not play
• Disc is upside down. Ensure the printed
side is upwards.
• Disc is dirty. Clean the disc with a
clean, soft, lint-free cloth. Wipe the disc
outwards from the center.
• Disc is defective. Try another disc.
• Imcompatible disc is used. Try another
disc.
34 EN
Replace fuse (see
• Disc rating exceeds the restric setting.
Change the rating settings to lower one
(see 'Adjust video DVD settings' on page
28 ).
• Disc region code is not compatible with
the unit. Use disc with proper region
code. (see 'Region code' on page 37 )
Disc is blocked in the disc compartment
• Press and hold
No image
• Parking brake wire connection is
incorrect. Check the parking wiring. (see
'Connect parking brake cable' on page 13 )
Image fl ashes or distorted
• Video DVD settings do not match with
the DVD. Adjust video DVD settings (see
'Adjust video DVD settings' on page 28 ).
• Video connection is improper.
connections (see 'Connect wires: without
ISO connectors' on page 11 ).
Noise in broadcasts.
• Signals are too weak. Select other
stations with stronger signals.
• Check the connection of the car antenna.
• Change broadcast from stereo to mono .
Preset stations lost.
• Battery cable is not correctly connected.
Connect the battery cable to the terminal
that is always live.
Fuse is broken
• The Fuse type is incorrect.
a 15A fuse (see 'Replace fuse' on page
33).
• Speaker wire or power wire is grounded.
Check the connections.
Display show ERR-12
• USB/SD/MMC data error. Check the USB
device or SD/MMC card.
until the disc comes out.
Check the
Replace it with