Hisense Y-H1 Instruction Manual page 6

Operation instructions
SMART mode
Press the SMART button, the unit enters SMART mode(fuzzy logic operation) directly regardless of
the unit is on or off. In this mode, temperature and fan speed are automatically set based on the
actual room temperature.
Operation mode and temperature are determined by indoor temperature
Heat pump models
Indoor temperature
Below T-3℃
≦Tindoor≦
T-3℃
Over T+3℃
Cooling only models
Indoor temperature
T+3℃ or below
Over T+3℃
SMART button is ineffective in SUPER mode.
Note: Temperature, airflow and direction are controlled automatically in SMART mode.
However, a decrease or rise of up to 7 ℃ can be set with the remote controller if you still
feel uncomfortable.
Your feeling
Uncomfortable
because of
unsuitable air
flow volume.
Uncomfortable
because of
unsuitable flow
direction.
Uncomfortable
because of
unsuitable flow
direction.
CLOCK button
You can adjust the real time by pressing CLOCK button, then
using and
CLOCK button again the real time is set.
Operation mode
HEATING
T+3℃ FAN ONLY
COOLING
Operation mode
FAN ONLY
COOLING
What you can do in SMART mode
button
Indoor fan speed alternates among
High, Medium and Low each time this
button is pressed.
Press it once, the vertical adjustment
louver swings to change vertical airflow
SWING
direction. Press it again, swings stops.
Press it once, the horizontal adjustment
SWING
louver swings to change horizontal airflow
direction. Press it again, swings stops.
buttons to get the correct time, press
Target temperature
T
T
T
Target temperature
T
T
adjustment procedure
5
CLOCK
MODE TIMER ON TIMER OFF
SMART SLEEP DIMMER
SWING
MUTE
SWING TEP SWITCH
I FEEL SOFT