Microlife FH 80 Manual page 2

Important Information - Retain for future use!
WARNING: Never use the pad without the cloth cover.
• Destination: the medical heating pad FH 80, FH 300 is for
Allow some air circulation between the pad and skin
warming the human body.
• Application scope: This device is not intended for medical during use.
use in hospitals: For household use only. 1. Put the cloth cover 1 on a flat surface. Open the fastener.
• To avoid any risk of electric shock when using the pad 2. Insert the pad 3 completely into the cover, fitting one side
please observe the following: at a time. Make sure the cable and hand control 2 remain
- Do not use if wet. If the pad has become damp or wet,
outside the cover.
completely dry the pad before use.
3. The pad will lie flat, filling the entire cover. Close fastener.
- Only use the pad in dry rooms, not e.g. in the bathroom.
4. Plug into a 220-240 volt AC mains socket and set the hand
- Check that the pad is undamaged each time before use,
control to the desired heat setting using the slider.
i.e. do not use it if there is visible damage to the hand
• Select the temperature setting on the slider – this
control, switches, plug or the pad itself.
switches on the heat pad. An indicator will illuminate,
- Do not insert pins or other sharp objects.
showing that the appliance is connected to the power
• To avoid overheating:
supply and is switched on.
- Do not leave the pad switched on unsupervised; switch it
• Setting 1 is recommended for continuous use.
off when you leave the room.
• The pad is switched off by moving the slider to the «0»
- Do not use the pad while folded.
position. The indicator light will then turn off.
- Avoid creasing the pad.
5. Apply the heating pad to a necessary part of the body.
- Do not cover the hand control! To ensure that the hand
6. The hand control will automatically turn off the heater
control functions correctly, do not place it on or under the
after approximately 90 minutes, then the indicator light will
heating pad or cover it with other objects.
flash until reset or turn off. To reset the timer and start a
- The cable should not be wound around the hand control.
further heating period, move the slider to the off «0» position
• Do not use on a person incapable of movement, a baby,
and then back to the desired heat setting.
a person insensitive to heat, or animals. Do not let chil-
7. Unplug when finished.
dren play with the device.
3. Cleaning Instructions
• Ensure that children do not use this device unsupervised.
Children under 8 years of age must not use this device unless
WARNING: Always unplug the power cable from the
a parent or guardian has set the control to the lowest temper-
mains socket before undertaking any cleaning of the
ature setting 1.
product.
• This device may be used by children aged 8 or over and by
1. The cover can be machine washed after removal from the
people who have reduced physical, sensory or mental abili-
pad according to the washing instructions given on the cover.
ties or inadequate experience and/or knowledge, provided
2. The pad must not be machine washed or dry-cleaned.
they are supervised or have been instructed on how to use
The FH 80, FH 300 (PVC surface) can be cleaned by using
the device safely and have understood the resulting dangers.
a soft damp cloth.
• Excessive application at a high setting can result in skin
3. Do not allow the hand control to get wet. Do not use any
burns.
detergents or solvents as they may damage the device.
• When the device is likely to be used for an extended
4. Never hold the hand control under water. Otherwise moisture
period, i.e. by the user falling asleep, controls should be
may enter the hand control and cause damage.
adjusted to a setting recommended for continuous use.
5. Check the hand control for signs of damage. Dry the pad and
• Examine the device frequently for signs of wear or
its fabric cover completely before switching it on again.
damage. If there are signs of wear or damage or the device

Cleaning and user maintenance shall not be made by
has been misused, please contact the manufacturer or
children without supervision.
authorised agent prior to any further use.
• If the power cable is damaged, it must be replaced by the 4. Explanation of Symbols
manufacturer, an authorised agent or similarly qualified
persons in order to avoid any hazards.
Wash at 40 °C!
• Do not attempt to open or repair the device yourself.
Special tools are required to re-assemble the device.
• Allow the device to cool down before folding and storing
Do not wash!
it in a dry place. Do not place heavy objects on it to prevent
buckling.
Bleaching not
Not suitable for children between 0-3 years! Children
permitted!
under 3 years of age are unable to respond to overheating.
Iron at low
1. Contraindications
temperature!
This device emits very weak electrical and magnetic fields
which may disturb the function of your cardiac pacemaker.
Read the instructions carefully before using this device.
Therefore, we recommend you to consult your physician and the
manufacturer of your cardiac pacemaker before using this device.
Type BF applied part
2. How to Use a Microlife Heating Pad
Electronic devices must be disposed of in accordance
1 Soft fabric cover – removable
with the locally applicable regulations, not with domestic
and machine washable.
waste.
Fastener.
2 Hand control with slider for
heat settings and ON indi- Class II equipment
cator.
Lot number
3 Pad
1 FH 0 8
EN
Do not iron!
Do not dry-clean!
Tumble-dry!
Do not dry in the tumble
dryer!
Guarantee Card
❑ FH 80 ❑ FH 422
Name of Purchaser /
Ф.И.О. покупателя
Serial Number /
Серийный номер
Date of Purchase /
Дата покупки
Specialist Dealer /
Специализированный дилер
FH 80 / FH 422