Advertisement
3 3 . . I I N N S S T T A A L L L L A A T T I I O O N N – – M M I I D D I I M M A A S S T T E E R R V V e e c c t t o o r r
3.
3.
INSTALLATION
INSTALLATION
3.1 Mechanical
3.1
Mechanical Installation
WARNING
WARNING
THIS EQUIPMENT MUST BE EARTHED.
THIS EQUIPMENT MUST BE EARTHED.
This equipment must
This equipment must not
To guarantee the safe operation of the equipment it must be installed and commissioned properly
To guarantee the safe operation of the equipment it must be installed and commissioned properly
by qualified personnel in compliance with the warnings laid down in these operating instructions.
by qualified personnel in compliance with the warnings laid down in these operating instructions.
Take particular note of the general and regional installation and safety regulations regarding work
Take particular note of the general and regional installation and safety regulations regarding work
on high voltage installations (e.g. VDE), as well as the relevant regulations regarding the correct
on high voltage installations (e.g. VDE), as well as the relevant regulations regarding the correct
use of tools and personal protective gear.
use of tools and personal protective gear.
Mount the inverter vertically to a flat, non combustible surface. Make sure that the unobstructed
Mount the inverter vertically to a flat, non combustible surface. Make sure that the unobstructed
clearance for each of the cooling inlets and outlets above and below the inverter is at least 100
clearance for each of the cooling inlets and outlets above and below the inverter is at least 100
mm.
mm.
Environmental requirements are described in section 1.1
Environmental requirements are described in section 1.1
The MIDIMASTER Vector must be secured to a suitable load-bearing wall by M8 bolts, washers and nuts.
The MIDIMASTER Vector must be secured to a suitable load-bearing wall by M8 bolts, washers and nuts.
Frame size 4, 5 and 6 units need four bolts. Frame size 7 units should be lifted using the two lifting holes and
Frame size 4, 5 and 6 units need four bolts. Frame size 7 units should be lifted using the two lifting holes and
secured by six bolts.
secured by six bolts.
W W
D D
Figure 3.1.1:
Figure 3.1.1: MIDIMASTER Vector - Fram
MIDIMASTER Vector - Frame Size 4, 5,
© Siemens plc 1999
© Siemens plc 1999
-
- MIDIMASTE
MIDIMASTER Vector
Installation
not b e energised with the cover removed.
b e energised with the cover removed.
H H
D D
e Size 4, 5, 6 and 7
R Vector
H H
D D
6 and 7
25 25
H H
G85139-H1751-U529-D1
G85139-H1751-U529-D1
E E n n g g l l i i s s h h
H H
D D
4/8/99
4/8/99
Advertisement
