Advertisement
1 1 . . O O V V E E R R V V I I E E W W
Use a variable AC supply. Apply 25% of
Use a variable AC
30 minutes.
30 minutes. Increase volts to
Increase volts to 75% for further 30
Now ready
Now
ready for
for run
run signal
signal (preparation
• •
3 3 years
years and
and over:
over:
As with 2
As wi
th 2 - 3
- 3 years,
years, but
1.3.4
1.3.4 Operation
Operation with Long
with Long Cables
Motor cable lengths vary depending on type of cable, power rating and voltage rating - and in some cases can
Motor cable lengths vary depending on type of cable, power rating and voltage rating - and in some cases can
be as long as 200m without the need for additional chokes. Refer to DA64 catalogue for further details.
be as long as 200m without the need for additional chokes.
In any case, all inverters will operate at full
In any case, al
l inverters will operate at full specification with cable le
50m for unscreened cables.
50m for unscreened cables.
© Siemens plc 1999
© Siemens plc 1999
supply. Apply 25% of input voltage for 30
input voltage for 30 minutes.
75% for further 30 minutes.
(preparation time
time 2 2 hours).
but the ste
the steps sh
ps should be
ould be 2 hours
Cables
specification with cable lengths up to
minutes. Increase volts to
minutes. Increase volts to
Increase volts to 100% for a
hours).
2 hours (preparation
(preparation time 8
time 8 hours).
Refer to DA64 catalogue for further details.
11 11
Increase volts to 50% for a further
50% for a further
100% for a further 30 minutes.
further 30 minutes.
hours).
ngths up to 25m for screened cable or
25m for screened cable or
E E n n g g l l i i s s h h
G85139-H1751-U529-D1
G85139-H1751-U529-D1
4/8/99
4/8/99
Advertisement
