Mytrex MXD3G Quick Install Manual

MXD3G Quick Install Guide

Box Contents

1. MXD3G All in One Cellular PERS device
2. 7-inch Cellular Antenna
1

Installation Requirements

1. Make sure that device is registered.
2. If you have ANY questions throughout this process, please contact your service provider.

Installation Steps

1. Bring the antenna upright to a vertical position
and tighten securely.
2. Plug the MXD3G power cube into an AC power
outlet not controlled by a light switch.
3. The MXD3G will automatically turn on and
announce "System Initializing."
4. Soon, the unit will speak the signal strength
followed by either
"Insufficient Cell Service." It is important that
the signal strength be 2.5 bars or better. If the
signal strength is not sufficient, the MXD3G may
not activate with the cellular company or
function properly. Please relocate the MXD3G
to another location. Wait 30 seconds and press
the RESET button. If the signal strength is not
adequate, try another location and repeat.
5. The Status light located on the left edge of the
large HELP button will appear green, indicating
the MXD3G is connected properly and the
cellular radio has been activated with the cellular
company.
6. Test the range of the PHB to make sure it works
throughout the home and yard. See Testing the
PHB (Range Test Mode) section.
7. Initiate your first call to the Response Center by
pressing the PHB or the HELP button. Contact
your provider if the MXD3G does not connect.
2
"System Ready"
or
3. Personal Help Button (PHB)
4. This Quick Install Guide
3
Not controlled by
a light switch!
Power Cube
Status Indicator
Mytrex MXD3G with Telguard inside - MXD3G QIS v1.0
4
Cellular Antenna
RESET T/L
Programming Jack