Safety Precautions And Instructions; Correct Installation - Smeg UG511DUK Translation Of The Original Instructions

3 SAFETY PRECAUTIONS AND INSTRUCTIONS

The precautions and instructions below contain important information and must be read with care.
The manufacturer does not accept responsibility for damage caused by failure to comply with the
safety precautions and instructions.

3.1 Correct installation

 The dishwasher must be installed by an authorised technician.
 When handling and installing the dishwasher, always wear the most suitable personal
protection equipment (PPE) for the task in hand.
 Do not install a dishwasher which has been damaged during transport. If in doubt, consult
your dealer.
 If the power supply cable is damaged, do not run the dishwasher.
 Do not install the dishwasher in areas subject to freezing temperatures or in atmospheres
with explosion risk (ATEX).
 Any accessories may only be installed on the appliance if authorised by the manufacturer.
 Do not install the dishwasher next to appliances which irradiate strong heat (e.g. gas burners,
stoves, etc.) since they could cause damage.
 If the dishwasher is installed above the ground, make sure that the stand and dishwasher
are secured properly and do not constitute a hazard.
 Electrical safety is only ensured if the dishwasher is connected to an earth conductor
compliant with the relevant electrical regulations. If in doubt, have the system inspected by
a qualified electrician.
 A circuit breaker and overcurrent protection device (magnetothermal switch or fuses) must
be installed in an easily accessible position on the dishwasher's power supply line. This device
must only serve the dishwasher and must be suitable for its rated electrical characteristics.
 Do not connect the dishwasher to the electrical mains by means of adapters or extensions,
since they do not guarantee the safety required.
 If the dishwasher is connected to the electrical mains by means of a plug, it must be of the
same type as the power socket, suitable for the appliance's rated electrical characteristics
and compliant with the relevant national regulations on electrical systems. The power plug
must be easily accessible after the appliance has been installed.
 Only use new hoses for connection to the water supply. Old hoses or hoses salvaged from
previous installations must not be used.
 The drain connection must be made in accordance with the relevant national regulations.
Substandard connections may cause flowback and in some cases pollution.
 If the machine is not installed in a recess, ask the manufacturer for the special
mounting kit in order to make it stable.
5