Technical Specifications - Skil 0525 Instructions Manual

SKIL0525_90x145
GB
Digital tape measure
INTRODUCTION
This tool is intended for measuring
distances digitally
Pay special attention to the safety
instructions and warnings; failure to
follow these may result in serious
injury
Read and save this instruction
manual 1

TECHNICAL SPECIFICATIONS

Measurement range
Power supply
Operating temperature
Storage temperature
Weight
Accuracy
SAFETY
During reeling in, the whipping of the
measuring tape may cause injury;
always reel in the measuring tape in
steps, and keep hands away from the
measuring tape when reeling in 2
Do not operate the tool with children
around
This tool should not be used by people
under the age of 16 years
Do not use the tool for any purpose
other than those mentioned in this
instruction manual
TOOL ELEMENTS 3
A Reel-in button
B LCD display
C On/off button
D Button for clearing memory ("MC")
E Button for adding values to memory
("M+")
F Button for retaining measured values
("Hold")
G Button for adding length of tool
housing
H Button for reading memory ("MR")
12-12-2005
J Measuring tape
K Battery compartment cover
L Measured value and measurement unit
0525
M Indicator of number of additions
N Symbol for retaining measured value
P Storage of measured values
Q Symbol for measurement with/without
length of tool housing
R Battery indicator
USE
On/off
- switch on the tool by pressing
- the tool automatically switches off
0 to 5 m
Mounting of battery 4
1x DC LR6/
! ensure that the tool is switched
1,5 V battery
-5°C to 50°C
- use exclusively alkaline-manganese
-20°C to 85°C
0,23 kg
- open cover K
maximum
- insert 1,5 V battery (pay attention to
deviation of
+/- 1 mm
- close cover K and ensure it is in
- when battery level is low, symbol
! change battery in time, otherwise
- always remove the battery from the
Operating the tool
! before switching on the tool,
- when the measuring tape is not
- press "on/off" button C
- place the tool at the starting-point of
4
16:51 Pagina 4
"on/off" button C
after 5 minutes of inactivity
off
or rechargeable batteries
correct polarisation)
place securely
R 3 will appear in display
faulty measurements may occur
tool, if the tool is not used for a long
period
press button A and reel in the
measuring tape completely
reeled in before switching on,
symbol 5 appears in display; reel in
measuring tape completely
(symbol 6 appears in display)
the measurement, take the
measurement, and read out the
measured value on the display
(= measurement without length of
tool housing) 7