MedPro 705-470 Instructions Manual page 11

1. Disconnect the tubing from the compressor and from
the bottom of the nebulizer cup.
2. If there is any moisture (condensation) in the tubing, let
the compressor run with only the tubing attached to it
for 2-3 minutes. The warm air from the compressor will
dry out the tubing. Alternatively, you can dry the tubing
by removing it from the compressor and hanging it with
the ends down to allow the moisture or condensation
to drain out and evaporate. Use a clean damp cloth to
wipe the tubing's exterior.
3. Disassemble the accessories.
4. Wash all parts with warm water and liquid dish soap.
DO NOT WASH THE TUBING.
5. Rinse thoroughly with warm water and shake to remove
remaining water.
6. Air dry or hand dry the nebulizer parts on a clean,
lint-free cloth. Reassemble nebulizer when parts
are dry and store until next use.
7. You can also wash the accessories in the dishwasher's
top rack. Masks cannot be washed safely in the
dishwasher. DO NOT WASH THE TUBING. Place
the parts in a dishwasher basket and place the basket
on the top rack of the dishwasher. Remove and dry
when the washing cycle is complete.
9