Set The Type Of Printer At The Club - Gantner BENZING M1 Manual

BENZING M1 - Club
MENU FUNCTIONS→MISCELLANEOUS

5.5.4 Set the Type of Printer at the Club

Within this menu the type of printer which is used in the club to produce the print-outs is
selected. Possible types are a printer which only prints font (ASCII) ("Standard"), a dot
matrix printer with continuous paper ("Matrix") or a "PC Simulation". With the selection "PC
Simulation" you have the possibility to display the print-out on a connected PC before it is
printed. Therefore the software "PrtSim.exe" has to be installed and started on the PC. If
you then print with the BENZING M1, the print-out will be shown on the PC screen. From
the PC you can then send the print-out to a printer that is connected to the PC.
[MISCELLA]
[ADJUST]
[PRINTER]
TA PRINTER
Standard
Matrix
PC Simulation
QUIT
[ ] or [
[ ]
[OK]
TA PRINTER
'Matrix'
activated!
Back to selection menu 'Adjust'
52
(blue)
(red)
(red)
18:24:58
.
OK
] - Move line marker (dark bar) up / down
- Select type of printer -> marker 'O' is set.
(green)- Confirmation of the selected type of printer. Only after
this step the printer selection will be saved!
18:25:22
Selected printer
Cursor mark
[OK] is only displayed after a new printer has
been selected.
... Confirmation of selection of printer is displayed
HB_BENZING-M1_CLUB-EN_13.doc
GANTNER Pigeon Systems GmbH