Installation And Operation; Conditions Of Use; Installation Of The System At The Club - Gantner BENZING M1 Manual

BENZING M1 – Club

INSTALLATION AND OPERATION

3. INSTALLATION AND OPERATION
3.1

Conditions of Use

The BENZING M1 and all BENZING equipment are electronic devices running at low voltage.
They should only be used inside and direct contact with water (drops or splashes of water,
stagnant water etc), dirt, and when in operation also with direct sunlight is to be avoided.
During operation the surrounding temperature for all devices has to be between 0°C and
+60°C (+32°F and +140°F). If the temperature drops down to less than 0°C (+32°F)
(which means that possibly condensed water is formed) the equipment has to brought to
dry for approx 1 hour at a room temperature of approx. +20°C (+68°F). Afterwards all
devices can be used again without further problems. The storage temperature ranges
between -25°C and +70°C (-13°F and 158°F).
3.2

Installation of the system at the club

At the club the BENZING M1 of a fancier is connected to a BENZING ClubSystem or
clubPOINT (previous system) using the enclosed BENZING M1 club cable. Subsequently,
other devices like the power supply unit or the printer etc. are connected to the BENZING
ClubSystem. After having connected all parts of the system the power supply unit is
connected to the mains.
Power supply of the BENZING M1 at the club is always provided with the BENZING M1 club
cable.
When installing the system it is of utmost importance that you also observe the
indications of the enclosed package leaflets which come with the corresponding
!
system components.
The way the system is installed at the club is displayed in figure 3.1, which shows how to
use the BENZING ClubSystem. Installation by using these older devices is possible as well
and is explained in figure 3.2. No system set-up is possible in combination with the club
Cobox!
12
HB_BENZING-M1_CLUB-EN_13.doc
GANTNER Pigeon Systems GmbH