Seasonal Maintenance; Pre-Season; During Season; End Of Season - Seeley Climate Wizard CW-6S Microcore Owner's Manual

SEASONAL MAINTENANCE

Seasonal Maintenance services must be
performed before, during and after the
summer season.
For the CW-6S Microcore Rooftop Unit

Pre-Season

1. Ensure the rooftop unit is switched
OFF at the MagIQtouch controller.
2. Remove the side panels as shown on
the previous page.
3. Remove the filter elements from each
side panel. Inspect, and if necessary,
replace. If reusing filter elements,
ensure they are replaced in the same
orientation (dirty face outwards).
4. Replace side panels.
5. Turn on water supply to the rooftop
unit (if turned off at end of season).
6. Run the rooftop unit.
WARNING! Ensure the pad frames are
fitted when operating the rooftop unit.

During Season

The return air filter must be checked and
cleaned by the owner/user at least once
every 2 weeks during the heating season.
This grille is part of the ductwork, and is
usually fitted by the installer to a wall or
ceiling inside the house. You can use a
vacuum cleaner to clean the return air
filter.
If you are unsure how to find, remove,
and clean the return air filter, then please
contact your local Seeley Dealer or your
installer.
Cleaning the return air filter regularly will
help to keep the heater running efficiently.

End of Season

1. Isolate power from the rooftop unit.
One way of doing this is to disconnect
the plug from the power outlet in
the ceiling space. Another is to turn
the Mains Circuit Breaker (MCB)
associated with the rooftop unit OFF.
2. Turn off water supply to the rooftop
unit.
3. Remove the side panels as shown on
the previous page.
4. Thoroughly clean the tank, pump filter
and salinity probe.
5. Reinstall side panels.
6. Reconnect power to the rooftop unit.
7. Trigger a manual drain from the
MagIQtouch controller.
8. Clean the return air filter inside the
building.
CW-6S MICROCORE OWNER'S MANUAL |
18