GE GEC-4VDPBC Installation Sheet page 6

Control Room Installation
GEC-4VDPBC and GEC-16VDPBC
Turn off external power supply.
Video: Use short coax patch cords to connect the BNC video inputs of video
receiving devices such as DVRs or matrix switches.
Data*: Connect each RJ-45 data connector to a Cat-5 cable carrying 4 data
signals to the PTZ controller.
Camera Cable: Connect each camera RJ-45 connector to the appropriate
camera Cat-5 cable.
Power: Connect the camera power input connectors to the external class II
power supply. Make sure that the power requirement is within the
recommended range. Turn on the external power supply.
Important Note: Do not overload the power supply.
GEC-8PVPDTCHUB and GEC-16PVPDTCHUB
Turn off main power switch on the combiner receiver unit.
Video: Use provided 2 ft. (60 cm) coax patch cords to connect the BNC video
inputs of video receiving devices such as DVRs or matrix switches.
Data*: Connect each RJ-45 data connector to a Cat-5 cable carrying 4 data
signals to the PTZ controller.
* In starting a configuration use a data distribution unit to populate the single
data line from DVR. Then run the outputs of the data distributor to RJ-45 data
connectors of the combiner. You may need to use a 110 junction block to
connect the output of the GE data distributor to the RJ-45 data connectors.
Camera Cable: Connect each camera RJ-45 connector to the appropriate
camera Cat-5 cable.
Power: Make sure that the power requirement is in the recommended range.
Connect the AC power cord to the AC power outlet and turn on the power switch
on the unit.
Important Note: Do not overload the power supply.
Make sure that the pin-out of the RJ-45 connectors matches the illustrated color
code of the Cat-5 wires.
6 of 11 P/N 1069686 • REV 1.0 • ISS 10MAR10