Cisco UCS B420 M4 Installation And Service Note page 10

Installing a Blade Server
Figure 4: Removing a Slot Divider
Tip
Step 2 Grasp the front of the blade server and place your other hand under the blade to support it.
Figure 5: Positioning a Blade Server in the Chassis
Step 3 Open the ejector levers in the front of the blade server.
Step 4
Gently slide the blade into the opening until you cannot push it any farther.
Step 5 Press the ejectors so that they catch the edge of the chassis and press the blade server all the way in.
Step 6
Tighten the captive screw on the front of the blade to no more than 3 in-lbs. Tightening only with bare fingers
is unlikely to lead to stripped or damaged captive screws.
Cisco UCS B420 M4 Blade Server Installation and Service Note
8
To reinstall the slot divider, align it with the dimples in the slot top and bottom and slide it back
in until it clicks into place.
Installing a Blade Server