Philips FW880PP/22 Instructions For Use Manual page 9

FW880P-880W/22-Eng 6/15/00
3 Press the BALANCE L to adjust the desired sound
level of front left speaker.
™ The display will show BAL L+XX.
4 Press the BALANCE R to adjust the desired sound
level of front right speaker.
™ The display will show the sound level and BAL
R +XX.
5 Press the CENTER + or - to adjust the sound
level of center speaker.
™ The display will show either CENT +XX or
-XX.
6 Press the REAR + or - to adjust the desired
sound level of surround speaker.
™ The display will show either REAR +XX or
-XX.
7 Adjust the sound level of all the speakers until they
are of the same apparent loudness. When you are
satisfied with the setting, press TEST TONE again to
switch off the test signal.
Note:
– It is advisable to set the speakers' level at normal
listening level." XX " denotes the sound level.
When you have completed the Dolby Pro Logic setup,
you are ready to experience and enjoy a Home Cinema
sound ambience.
• Press DOLBY PRO LOGIC (DPL) repeatedly to select
and cycle through the various sound mode.
Dolby Surround ™ Center Phantom ™ Dolby 3
Stereo ™ Stereo ™ Dolby Surround ...
™ The Dolby Pro Logic Control display panel will light
up with the respective selection.
4:06 PM Page 9
Dolby Surround
This setting is for a full Dolby Surround Pro Logic mode.
• Press DOLBY PRO LOGIC to select the Dolby
Surround mode.
™ The display message
"DOLBY
SURROUND" will
be displayed.
™ The DPL Control
display panel will light up.
Dolby Center Phantom
This setting is for use without the center speaker. It
redistributes the center channel information to the left
and right speakers providing conventional stereo across
the front.
• Press DOLBY PRO LOGIC to select the Dolby Pro
Logic Center Phantom mode.
™ The display message
"CENTER
PHANTOM" will
be displayed.
™ The DPL Control
display panel will light up.
Dolby 3 Stereo
This setting is for use where full surround is not
required, but a wide stereo sound is desirable. It only
requires the left, right and center speakers.
• Press DOLBY PRO LOGIC to select the Dolby 3
Stereo mode.
™ The display message
"DOLBY 3
STEREO" will be
displayed.
L C R
™ The DPL display
panel will light up.
DOLBY PRO LOGIC
S
S DISPLAY
Normal Stereo
This setting is for normal stereo sound without Dolby Pro
Logic. It only requires the left and right speakers.
• Press DOLBY PRO LOGIC to select the Stereo mode.
™ The display message
"STEREO" will be
displayed.
™ The DPL display
panel will light up.
Important!
L C R
1. To listen to the optimum Dolby Pro Logic sound effect,
it is recommended to switch on DPL in combination
with "Classic" and without Incredible Surround.
DOLBY PRO LOGIC
S S
DISPLAY
2. Dolby Pro Logic mode will automatically switch to
normal Stereo mode when a headphones is
connected.
3. It is recommended to switch to normal stereo mode
when you do recording on a tape.
DOLBY PRO LOGIC
L R
C
DOLBY PRO LOGIC
S S
DISPLAY
L C R
DOLBY PRO LOGIC
S
S DISPLAY
9