Fujitsu LIFEBOOK P8010 Manual page 61

Problem
Shutdown and Startup Problems
BIOS setup changes were
Your notebook
appears to change not saved when you made
setup parameters them and exited the BIOS
setup utility.
when you start it.
The BIOS CMOS hold-up
battery has failed.
The system may be
Your system
display will not turn password protected.
on when the
system is powered
on or when the
system has
resumed.
Video Problems
The notebook is set for an
The built-in display
is blank when you external monitor only.
turn on your
LifeBook notebook.
The angle and brightness
of the display are not
properly set at your
lighting conditions.
Possible Cause
Make sure you select Save Changes And Exit
when exiting the BIOS setup utility.
Contact your support representative for
repairs. This is not a user serviceable part. The
part has a normal life span of 3 to 5 years.
Check the status indicator panel to verify that
the Security icon is blinking. If it is blinking,
enter your password.
Pressing [F10] while holding down the [Fn] key
allows you to change your selection of where
to send your display video. Each time you
press the combination of keys you will step to
the next choice. The choices, in order, are:
built-in display only, external monitor only, both
built-in display and external monitor.
Move the display and the brightness control
until you have adequate visibility.
Tr o u b l e s h o o t i n g
Possible Solution
49