Adding Memory; Where To Install Memory; Preparing Necessary Items; Installing Memory Module - Fujitsu LIFEBOOK P8010 Manual

ADDING MEMORY

Where to install memory

Your notebook has an expansion RAM module
slot (slot 2) to add in one additional memory
module.
The memory capacity of the notebook can be
increased to a maximum of 4 GB (2048 MB x 2).

Preparing necessary items

• Philips screwdriver
Use a screwdriver of appropiate size to
remove the screws on the cover. Failure to
do so may damage the head of the screws.
Memory Module Configuration Table.
The table below shows combinations of
memory that can be installed on your
notebook.
The installation of any combination of memory
other than the combinations shown below can
impair the functioning of your notebook.
Total capacity Slot 1 Slot 2 Remarks
512 MB 512 MB DDR2 667MHz
512 MB 512 MB Dual Channel DDR2 667MHz
1 GB
1 GB 1 GB DDR2 667MHz
1 GB
2 GB 1 GB Dual Channel DDR2 667MHz
2 GB 2 GB DDR2 667MHz
4 GB 2 GB 2 GB Dual Channel DDR2 667MHz
This LifeBook is capable of operating in dual
channel memory mode. To realize the full
performance benefits of dual channel operations,
we recommend you upgrade memory module
using Fujitsu memory module such that the two
memory modules in the memory slots are of the
same capacity and specification.
Adding Memory

Installing memory module

To install memory, perform these steps.
Before installing any memory module,
remember to power off the notebook
and disconnect the AC adapter from it.
Keep small objects, such as a cover,
caps and screws, out of the reach of
babies and children. These small
objects may suffocate a baby or child if
they are swallowed accidentally. Should
such an accident happen, consult a
doctor immediately.
Cer tain components around the
memory slots are very hot when the
notebook is powered on for a long period
of time.
To avoid possible burns, do not install
or remove memory module immediately
after turning off the notebook but wait
for a while until its internal components
cool down.
To install or remove a memory module,
hold it by the edge and be careful not to
touch any component and IC.
Memory module is made of materials
sensitive to human body static charges.
Before handling a memory module,
always touch an appropiate metal object
to discharge static charges from your
body.
Please remember to turn off the
notebook before you begin to install or
remove a memory module. If the
notebook is placed in standby or
hibernate mode while the memory is
removed, data may be lost or corrupted.
This may also damage the memory
module.
35