Advertisement
10.0 - ADDING NEW DEVICES
To carry out this operation successfully, you must first make the required electrical
!
connections (door switch, GREEN wire to ground and and positive under key).
The system can
record a maximum of 11 devices, either electronic keys or TAG CARDS.
To activate the procedure follow the indications reported below.
!
With the alarm system disarmed, open and keep opened the driver door and connect to ground the
GREEN wire.
The following operations must be carried out within four seconds otherwise the
!
!
Turn ignition key over 4 times: "ON-OFF"-"ON-OFF"-"ON-OFF"-"ON".
!
At the fourth rotation, keep ignition key "ON"
!
The buzzer will chirp twice and the turn indicators will flash twice to indicate the learning procedure
of new devices has started
.
Do not close the driver door otherwise the devices already saved will be deleted as
!
described in the next paragraph
!
The system is now ready to receive the device codes
!
Depending on the device to be recorded, either insert the electronic key into its receptacle or let the
system pick up the TAG signal
.
!
To indicate the new device is learned, the buzzer chirps once and the status LED blinks once
!
Repeat
the above steps to record
other devices.
!
Turn ignition key to "OFF", close the door and remove from ground the GREEN wire
!
When the procedure is completed, the siren buzzer once
Storing memory is for 11 devices. If you store an extra one it will automatically delete
!
the first device recorded in the system memory.
PAGE 08 - INSTALLER MANUAL
procedure is invalidated.
.
.
.
.
11.0 - DELETING PROGRAMMED DEVICES
To carry out this operation successfully, you must first make the required electrical
!
connections (door switch, GREEN wire to ground and and positive under key).
The system has a delete mode to remove a programmed electronic key or TAG CARD.
T
o activate the procedure follow the indications reported below
!
With the alarm system disarmed, open and keep opened the driver door and connect to ground the
GREEN wire.
The following operations must be carried out within four seconds otherwise the
!
!
Turn ignition key over 4 times: "ON-OFF"-"ON-OFF"-"ON-OFF"-"ON"
!
At the fourth rotation, keep ignition key "ON"
!
The buzzer will chirp twice and the turn indicators will flash twice to indicate that the delete
procedure has been initiated.
!
Close the door; the LED turns on steady.
!
Keep the bonnet closed for at least 8 seconds until all the devices are cancelled
!
The devices will not be deleted if the door is opened before 8 seconds.
! When this procedure is completed, the LED turns off, the buzzer chirps once and the turn indicators
flash once.
.
!
Turn ignition key to "OFF" and disconnect from gronud the GREEN wire
12.0 - WASTE ELECTRICAL AND ELECTRONIC EQUIPMENT
In the European Union, this lable indicated that this product should not be disposed of with household
waste. It should be deposited at an appropriate facility to enable recovery and recycling (directive
2002/95/CE, 2002/96/CE and 2003/108/CE).
For information on how to recycle this product responsibly in your Country, please visit the web-site:
www.eur-lex.europa.eu
.
procedure is invalidated.
.
.
.
(WEEE) DIRECTIVE
!
APPROPRIATE
CONTAINER ONLY
INSTALLER MANUAL - PAGE 09
.
Advertisement
