IntesisHome IHWFIPAN001R000 Installation Sheet

Intesis Software SLU

This document has been carefully written by Intesis Software SLU and a lot of effort has been made to

ensure no errors or mistakes are present in the document. Intesis Software SLU is not responsible for

printing or clerical errors.

Information in this document is subject to change without notice. No part of this publication may be

reproduced, stored in a retrieval system or transmitted in any form or any means electronic or

mechanical, including photocopying and recording for any purpose other than the purchaser's personal

use without the written permission of Intesis Software SLU

Intesis Software SLU

Milà i Fontanals, 1 bis

08700 Igualada

Spain

IntesisHome® is a trademark of Intesis Software SLU. Third party product names or company names

used in this document may be trademarks of their respective companies. Its use in this document is

purely for information purposes only.

This information is subject to change without notice

IntesisHome

is a registered trademark of

Intesis Software SLU

Installation Sheet

IHWFIPAN001R000

Installation Sheet

URL

http://www.intesishome.com

info@intesishome.com

1 / 4

Table of Contents

Need help?

Do you have a question about the IHWFIPAN001R000 and is the answer not in the manual?

Page 1 08700 Igualada Spain IntesisHome® is a trademark of Intesis Software SLU. Third party product names or company names used in this document may be trademarks of their respective companies. Its use in this document is purely for information purposes only.
Page 2 3 Device connection ............................3 4 External powering scheme ........................4 5 Switch configuration ..........................4 2 / 4 © Intesis Software SLU - All rights reserved This information is subject to change without notice http://www.intesishome.com Email info@intesishome.com IntesisHome ® is a registered trademark of...
Page 3 Access to the main Printed Circuit Board. • Locate the R1 / R2 socket connector. Select a location for the device. • Connect the IntesisHome device to the Air Conditioner. • Close the Air Conditioner unit. • Plug the AC to the power supply line.
Page 4 In case no external supply is used: In very specific installations, AC port consumption may be overpassed, leading the device to reboot. If that happened, decrease device consumption by using SW3 and SW4. NOTE: Remember that you need to power cycle the climate system or the IntesisHome device for the changes in the switches to be applied.