Additional Information; Switching Off The Alarm; Maintenance - Philips AJ3290/05 Instructions For Use Manual

ALARM/SLUMBER

SWITCHING OFF THE ALARM

You can switch off the alarm in three ways:
Unless you choose to cancel the alarm
completely, the ALARM RESET option will be
automatically selected after 59 minutes from the
time your alarm first goes off.
Alarm reset
If you want the alarm mode to be stopped
immediately, but also wish to repeat the alarm
call at the same time for the following day:
• Press ALARM RESET during the alarm call.
Repeat alarm
This will repeat your alarm call at 7 minutes
intervals.
• Press /REPEAT ALARM.
SLUMBER OFF
• Press /REPEAT ALARM again
SLUMBER OFF
during the next call if you wish to repeat the
alarm call.
• If, however, you do not press
/REPEAT ALARM again, the alarm will
OFF
sound for 59 minutes before turning itself off.
Your alarm time setting will then
automatically enter the ALARM RESET mode
to sound at the same time next day.
Cancelling the alarm completely
• Before or during the set alarm goes off, push
the AL (1 or 2) switch to the OFF position.
– The alarm indicator will disappear from the
display.
6

ADDITIONAL INFORMATION

SLUMBER
About SLUMBER time
The clock radio has a built-in timer device called
the SLUMBER, which enables the radio to be
automatically switched off after a set period of
time; this allows you to lie back, listen and fall
asleep. The maximum slumber time is 59
minutes.
Setting and switching off SLUMBER
1. Set the RADIO switch to the OFF position.
2. Set your slumber time by pressing on the
3. Release the button as soon as the required
4. To cancel the SLUMBER function, press
SLUMBER
Notes:
– The slumber function does not affect the
– If during SLUMBER you have turned down the

MAINTENANCE

– If you do not intend to use the clock radio for
– To clean your set from fingerprints, dust and
SLUMBER button. Keep your finger on the
button and the display will begin to count
down from 59 to 00 minutes.
slumber time is reached.
/REPEAT ALARM.
SLUMBER OFF
alarm setting(s).
volume and you have an alarm set in radio
mode, make sure you have adjusted the
volume loud enough to wake you up the next
day.
a long time, disconnect the set by removing
the plug from the wall socket. The battery
should also be removed to prevent chemical
leakage which will damage your set.
dirt, use a clean and soft damp cloth or
chamois leather. Do not use cleaning products
which contain benzene, thinner etc. as these
may harm the housing.