Philips AJ3226/93 User Manual

Clock radio dual alarm

Advertisement

Register your product and get support at
EN
ZH-CN
User manual
用户手册
AJ3226

Advertisement

Table of Contents
loading

Summary of Contents for Philips AJ3226/93

  • Page 1 Register your product and get support at User manual ZH-CN 用户手册 AJ3226...
  • Page 2 DOWN CLOCK RADIO AJ 3226 SLEEP ALARM 1 ALARM 2 EA T ALARM •SLEEP OFF• ALARM RESET...
  • Page 3: Clock Control

    Congratulations on your purchase, and welcome to Philips! To fully benefit from the support that Philips offers, register your product at www.philips.com/welcome. Controls (see fig. 1) a SLEEP • activates the radio for sleep function • adjusts the sleep period...
  • Page 4: Installation

    i ALARM RESET • stops the active alarm for 24 hours j DISPLAY • show the clock/ alarm times and status of the set k OFF • RADIO • AUX • switches off the set or selects the radio/AUX mode. l AL 1, AL 2 OFF switches off the alarm 1 or alarm 2 •...
  • Page 5 To disconnect the set from the mains supply completely, remove the plug from the wall socket. Note • The type plate is located on the bottom of the set. Clock memory backup The clock memory backup allows your alarm and clock time settings to be stored for up to a day when there is a power interruption e.g.
  • Page 6 Adjust TUNING to tune to your desired station. Turn the VOLUME control to adjust the volume level. Adjust OFF • RADIO • AUX to OFF to switch off the radio. To improve reception: FM: extend and position the pigtail for optimum reception. MW: uses a built-in aerial inside the set.
  • Page 7: Switching Off The Alarm

    Selecting the alarm mode GENERAL If you wish to use the alarm, you must first set the alarm time first. You can choose from two different alarm modes to wake you up: by radio or buzzer. Select your choice of alarm mode by adjusting AL 1 or AL 2 to •...
  • Page 8: Repeat Alarm

    Repeat alarm This repeats your alarm call at 6-7-minute intervals. During the alarm call, press REPEAT ALARM/SLEEP OFF. SLEEP About Sleep This set has a built-in timer which enables the set to be automatically switched off during radio playback after a set period of time. This allows you to lie back, listen and fall asleep.
  • Page 9: Safety Information

    Connect the AUX-IN cable of the set to an AUDIO OUT or headphone jack on an external device (such as MP3 player, or CD player). Safety information • Install the unit near the AC outlet and where the AC plug can be easily reached.
  • Page 10: Troubleshooting

    • Battery shall not be exposed to excessive heat such as sunshine, fire or the like. Caution • Use of controls or adjustments or performance of procedures other than herein may result in unsafe operation. Troubleshooting If a fault occurs, first check the points listed below before taking the set for repair.
  • Page 11: Environmental Information

    Continuous crackling/hiss disturbance during MW broadcast – Electrical interference from TV, computer, fluorescent lamp, etc. • Move set away from other electrical equipment The alarm does not function – Alarm time not set and or alarm mode not selected • Set the alarm time and / select alarm mode –...
  • Page 12: Specifications

    Specifications AC Power...220 V / 50 Hz Power Consumption Active ... 5 W Standby ...<2 W Dimensions (w x d x h) ...174 x 62 x 159 (mm) Weight ...0.52 kg...
  • Page 13 © 2011 Koninklijke Philips Electronics N.V. All rights reserved. AJ3226_93_UM_V1.0...

This manual is also suitable for:

Aj3226

Table of Contents