Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for DTronics DT-RDX
Summary of Contents for DTronics DT-RDX
- Page 1 DTRONICS DT-RDX User’s Manual FW version V1.2 DT-RDX MANUAL...
-
Page 2: Table Of Contents
Powering On & Off ................6 Firmware Version ................6 Memory ....................6 3 Common Section ................7 Init Function ..................7 4 Operator Section ................8 Operator Select ................... 8 Operator On/Off ................. 8 5 Backlight .................... 9 DT-RDX MANUAL... -
Page 3: Document Revisions
DTRONICS Document revisions Date Version Change 16-11-2018 R1.0 Initial document 12-01-2019 R1.1 Added: intended use, Index, DT-RDX MANUAL... -
Page 4: Setup
DTRONICS Setup Intended use The DT-RDX is intended to create new sounds for your synthesizer, It is possible to play your connected Synth over midi when the DT-RDX is attached. However this is not recommended and can result in unreliable data or ‘sticky notes’... -
Page 5: Connection
DT-RDX Now connect one male end of the Y POWER CABLE to the REFACE power port and the other end to the DT-RDX power port. Connect your REFACE power supply to the female end of the Y POWER CABLE. -
Page 6: Operation
Firmware Version The right 8 LEDS indicate the firmware version on power up. This image shows version 1.2 Memory in memory and recalled. As All switch settings are automatically stored long as the power supply is present. DT-RDX MANUAL... -
Page 7: Common Section
The left part of the control panel is the common section. Each knob of the common section affects the REFACE at any time. Init Function Press the INIT button to reset the REFACE to an empty patch. A nice feature to design a sound from scratch! DT-RDX MANUAL... -
Page 8: Operator Section
Up to 4 operators can be selected at the same time. Now all knobs of the operator section will affect to the selected operators. Operator On/Off Press the OP ON/OFF buttons to turn any operator On or Off. DT-RDX MANUAL... -
Page 9: Backlight
You can switch the orange glow on the back on or off. This setting is stored into memory. Make sure the DT-RDX is connected to the RefaceDX and the power is ON. wait until the programmer and reface have both completely finished their startup.
Need help?
Do you have a question about the DT-RDX and is the answer not in the manual?
Questions and answers