quiko QK-CE220BATRL4 Quick Manual

QK-CE220BATRL4
CONTROL BOARD FOR 230V SWING GATES
CHECKING IF THE MOTORS TURN IN THE RIGHT DIRECTION
Once all the connec ons have been done and the system is ready to start, before se ng the system
it is important to check that the motors turn in the right direc on. To do that:
1. Remove electricity.
2. Unlock both motors and manually put the leafs in the middle.
3. Give electricity.
4. Give a first start impulse to the system with remote control or push - bu on.
5. Make sure that both motors open.
6. If one or both motors closes instead, swap
MOTOR A
First motor to open, last motor to close.
13 15
13 open
13 14 15
14 common
MA
15 close
7. Once you have swapped motor/s phases cables, repeat the procedure above and make sure that
now both motors open at first start signal a er giving electricity.
8. The system is now ready for setup.
INSTALLING RADIO MODULE
Important no ce: radio module is by factory installed on the control board plas c box. The radio
signal range is good enough in most cases. Shall you wish to increase the radio range even more,
install the radio module as one the following examples.
ANTENNA HOUSING WITH
INSIDE THE ANTENNA HOUSING
op onal
QK-AN433_V4
Quiko Italy declares under their own responsibility that the product complies with the main safety requirements issued
by the following direc ves: 1) Radio Sets 1999/05/EC – 2) Low voltage 2006/95/EC – 3) Electromagne c compa bility
2004/108/EC and any revisions thereof, and complies with the provisions that implement said direc ves in the na onal
legisla on of the Country where the products are to be used.
®
QUICK GUIDE
V21
Hb2117
the phases cables of the motor/s that was closing.
MOTOR B
16 18
16 open
16 1718
17 common
18 close
INSIDE THE FLASHING LAMP
FLASHING LAMP
quikoitaly.com
MADE IN ITALY
®
MADE IN ITALY
MB
op onal QK-BRALUX