Table of Contents
Advertisement
Digital tuner
Digital tuner
Tuning to radio station
1 Press RADIO ON/OFF to switch on the
radio (FM only).
The radio station frequency and the
waveband will be displayed. (See 3).
2 Press and hold TUNING +/- until the
frequency in the display starts running.
The radio automatically tunes to a station
of sufficient reception.
3 Repeat step 2 if necessary until you find the
desired station.
•
To tune to a weak station, press TUNING
+/- briefly and repeatedly until you have
found optimal reception.
To improve reception:
FM: Extend and adjust the pigtail for optimum
reception.
Programming radio stations
You can store up to a total of 10 radio sta-
tions in the memory (10 FM) manually or
automatically (Auto store). Any previous
presets will be erased.
Manual programming
1 Tune to your desired station (see Tuning to
radio stations).
2 Press and hold PRESET +/- to activate
programming.
Display: PRESET flashes.
3 Press PRESET +/- once or more to allocate
a number from 1 to 10.
4 Repeat steps 1-3 to store other stations.
Helpful hints:
–
You can erase a preset station by storing
another frequency in its place.
Autostore
Autostore automatically starts programming
radio stations from preset 1. Any previous
presets e.g. manually programmed will be
erased.
1 In radio mode, press AUTO SCAN/DATE
until the frequency in the display starts
running.
Available stations are programmed (FM).
After all stations are stored, the first auto-
store preset station will then automatically
play.
To listen to a preset or autostored
station
Press the PRESET +/- buttons once or more
until the desired preset station is displayed.
Using the alarm
AJ260 allows you to simultaneously set two
different alarms (ALARM 1 and ALARM 2 )
which can go off in the radio or buzzer
mode.The clock time needs to be set
correctly before using alarm.
Setting alarm time
1 Press briefly ALM 1 or ALM 2 to display
AL1 or AL2 icon.
2 Press and hold ALM 1/ ALM 2 for two
seconds.
The hour digits flash.
3 Hold down or press TUNING +/- repeatedly
to adjust the hours.
4 Press ALM 1/ALM 2 to confirm the setting.
AL1/AL2 icon and the minute digits flash.
5 Hold down or press TUNING +/- repeatedly
to adjust the minutes.
6 Press ALM 1/ALM 2 to confirm the setting.
Helpful hints:
– In standby mode, press DATE to display
month and day information. In radio mode,
to display alarm time, press ALM 1/ALM 2.
Selecting alarm mode (activating)
1 Press RADIO ON/OFF to switch to
standby.
2 Select your choice of alarm mode: either
radio, or buzzer by using the RADIO•BUZ
slider.
3 Press ALM 1/ALM 2 once or more to
display
.
When alarm is activated,
(See 4).
•
At the set alarm time, radio or buzzer will
switch on automatically.
Alarm
is displayed.
Advertisement
Table of Contents
