Using On-Screen Menus - Sony TRINITRON PVM-2950QM Service Manual

Using on-screen menus
Operating through menus
There are four buttons (keys) on the monitor and the remote
commander for menu operations.
To display a menu, first press MENU. Press+ or - to move
the
cursor( ►)
and press ENTER to select an item.
To return to the normal screen, press the selected line input
button (key).
Menu operating buttons
Remote commander
SELECT
□
(MENU)
0
(ENTER)
Monitor
G
SELECT
G
Each time you press MENU, the screen changes as shown
below. For details sec the following guide.
8
MENU 1 LI NE 1
► CONTRAST
PHASE
CHROMA
BRIGHTNESS
BLUE ONLY
MATRIX
RESET1
♦
MENU2 LINE1
► H CENT
V CENT
H SIZE
V SIZE
RESET2
DEGAUSS
RETURN
♦
MENU3 LI NE 1
► APERTURE
VM
16:9
PAL
COL TEMP
RESET3
RETURN
♦
MENU4
50
00
00
00
:OFF
:OFF
00
00
00
00
32
ON
:OFF
:OFF
:6500
► TILT CORRECT: 00
INDEX NO.
:001
RETURN
+-
-
Menu guide
You can adjust the picture for each line input. Select the line
input by pressing the line input button (key) before making
adjustments.
The items on Menu 4 arc common for all line inputs.
lfo§,PII
[II
CONTRAST
ENU1 LINE1
~CONTRAST
PHASE
CHROMA
BRIGHTNESS
BLUE ONLY
ATRIX
RESET1
50
00
00
. 00
:OFF
:OFF
Press + to increase the contrast and press - to decrease it.
W
PHASE
Press + to make the skin tones greenish and press - to
make them purplish. (NTSC signal only)
(Set MATRIX to OFF when adjusting this item.)
~ CHROMA
Press+ to increase the color intensity and press - to
decrease it.
(Set MATRIX to OFF when adjusting this item.)
@]
BRIGHTNESS
l'ress + to make the picture brighter and press - to make
it darker.
~
BLUE ONLY
Select ON to turn off the red and green signals. Only a
blue signal is displayed on the screen. This facilitates
"chroma" and "phase"(NTSC signal only) control
adjustments.
[§]
MATRIX
Select ON to activate the matrix circuit that may correct
skin tones. (NTSC signal only)
[I]
RESET1
Select to restore the factory settings in MENU 1.
- 10 -