Power Supply - Philips AZ1040/17 User Manual

Whenever convenient, use the power supply if you want to
conserve battery life. Make sure you remove the plug from the
set and wall outlet before inserting batteries.
BATTERIES (NOT INCLUDED)
1. Open the battery compartment and insert six batteries, type
R-20, UM-1 or D-cells, (preferably alkaline) with the correct
polarity as indicated by the "
compartment.
2. Replace the compartment door, making sure the batteries are
firmly and correctly in place. The set is now ready to operate.
– If BATT LOW lights up, battery power is running low.
– The BATT LOW indicator eventually goes out if the
batteries are too weak.
Incorrect use of batteries can cause electrolyte leakage and will
corrode the compartment or cause the batteries to burst.
Therefore:
• Do not mix battery types: e.g. alkaline with carbon zinc.
Only use batteries of the same type for the set.
• When inserting new batteries, do not try to mix old batteries
with the new ones.
• Remove the batteries if the set is not to be used for a long
time.
Batteries contain chemical substances, so they should
be disposed of properly.
Using AC POWER
1. Check if the power voltage as shown on the type plate on
the bottom of the set, corresponds to your local power
supply. If it does not, consult your dealer or service center.
2. If your set is equipped with a voltage selector, adjust the
selector so to match with the local power supply.
3. Connect the power cord to the wall outlet and the set is now
ready for use.
4. To disconnect the set from the power supply completely,
remove the plug from the wall outlet.
+ -
" and " " symbols inside the

POWER SUPPLY

6 x R20 • UM-1 • D-CELLS
9