Channels - Display the scan sub-menu based on
。
。
different Channel installation modes.
Channel installati
n m
channel sources. You can select the signal type.
• Antenna - Set the signal type to antenna. When set to
Antenna,the 1V can receive analog and digital (DVBT.斤2)
broadcasting signals.
• Cable -Set the signal type to cable. When set to Cable,
the 1V can receive analog and QAM broadcasting signals.
• Satellite - Set the signal type to Satellite. When set to
Satellite, the 1V can receive Satellite broadcasting signals.
。
Aut
Channel Update - Press
When selecting ON, the system will automatically scan and
update channels after 5 minutes of standby.
。
。
。
。
Is - Press J;,J"f button to select the
Parental c
ntr
ption then press
K button to enter the sub-menu.
。
Audi
。
Channel - Press •IT button to select the
ption then press OK button to enter the sub-menu.
。
Open s
。
。
urce licenses - Press •l"fbutton to select the
pti
n then press OK button t
Antenna
。。
1.Menu->Se忧ings->Channel->Channel Installation Mode
enter, ch
se Antenna.
2. Enter Menu->Settings->Channel->Channels.
de -Select on-screen display
。
K button to choose ON/OFF.
。
enter the sub-menu.
3. Channel Scan directl }enters the A1V+D1V
automatic search platform interface of Antenna.
Update Scan: Re-automatically search for frequency
points outside the station.
。
Anal
g Manual Scan: Manual AlV search station.
After input the frequency point, you can select up
or down search station.
Single RF Scan: D1V manual search, left and right
after selecting RF Channel, directly OK search.
Cable
1.Menu->Settings->Channel->Channel Installation
Mode, select Cable.
2. Enter Menu->Settings->Channel->Channels.
14