Lennox ADAGIO-MN Installation Instructions Manual page 27

1. Place the rear log (A) as shown in Figure 44
on the bottom of the log over the corresponding locating pins (#1 &
#2) and against the log support bracket. See Figures 43 and 44 for
pin and rear bracket locations.
1
Figure 44 - Install Rear Log (A)
2. Place the left middle log (B) as shown in Figure 45
on the bottom of log B over the corresponding locating pin on Log A.
f i r e - p a r t s . c o m
B
Figure 45 - Install Left Middle Log (B)
3. Place the left front log (D) as shown in Figure 46
on the bottom of log D over pin# 3.
D
D
3
Figure 46 - Install Left Front Log (D)
Position the 2 holes
.
A
2
3
4
5
Position the hole
.
A
Position the hole
.
NOTE: DIAGRAMS & ILLUSTRATIONS ARE NOT TO SCALE.
4. Place the right front log (E) as shown in Figure 47
on the bottom of log E over pins #4 and # 5.
Figure 47 - Install Right Front Log (E)
5. Place the right middle log (C) as shown in Figure 48
C behind Log E and resting on the "flat" on Log A.
Figure 48 - Install Right Middle Log (C)
6. Ember Placement - Separate the Embers (rockwool) into pieces
about the size of a quarter (see Figure 43). Keep the pieces fluffed
up, not matted. Distribute these pieces over the surface of the burner,
as shown in Figure 49. Do not use more than is necessary. Ensure
that the main burner ports remain uncovered by the ember material
(see Figure 43).
Figure 49 - Ember Placement
Position the hole
.
E
Position log
.
C
A
E
DO NOT place ember material directly
over the ember burner ports.
27