Operation; Direction Control; Torque Control; Gear Selection - Teccpo TDHD02P Instruction Manual

Machine to test that it is running centrally, smoothly and evenly. If the bit is 'wobbling' or not
running centrally, release the chuck, check the accessory for damage,correct its position,
retighten and test again.

Operation

Direction control

WARNING: NEVER change the direction of rotation while the tool is running. This may cause
permanent damage to the tool.
- The direction of rotation can be set using the Forward/Reverse Switch (6)
- For anti-clockwise rotation, push the switch to the right
- For clockwise rotation, push the switch to the left
Note: When the Forward/Reverse Switch is in the central position,
6
the drill is locked and cannot be switched on. Use this setting as
a safety feature to prevent the drill from being switched on accidentally.

Torque control

Note: This cordless drill is equipped with a torque control clutch allowing the machine to be set to
the correct torque for the individual application.
- The clutch settings are indicated by the symbols on the
Torque Selector (2)
- Rotate the Torque Selector to select the desired setting:
the higher the number displayed on the torque ring,
the higher the torque produced by the too.

Gear selection

- Select gear 1 on the Gear Switch (4) for the higher torque.
A lower speed gear is generally more suitable for driving screws
and fasteners.
- Select gear 2 on the Gear Switch for the lower torque.
A higher speed gear is for drilling and must not be used
for driving screws and fasteners.
Note: ALWAYS read the documentation provided with drill bits and accessories for the
recommended or maximum speed setting and use the most appropriate gear. See 'Specification'
for the maximum no load speed of each gear.
Switching on/off
WARNING: ALWAYS wear adequate personal protection equipment when setting up and
operating this machine.
1. To start the drill, squeeze the Trigger Switch (7).
2. The built-in Work Light (9) will illuminate when the Trigger Switch is squeezed.
Note: If the Trigger Switch cannot be pressed down, check that the Forward/Reverse Switch (6)
is not set to its middle position, which locks the device (see 'Direction control' ).
3. The speed of the drill is controlled by the movement of the trigger: the further the Trigger
Switch is pressed down, the faster the drill will run.
4. Release the Trigger Switch to stop the machine.
- -
10