Before Use; Removing A Battery; Fitting A Battery; Setting Up The Battery Charger - Teccpo TDHD02P Instruction Manual

Before Use

Removing a battery

Remove the Battery from the tool by pressing the Battery Release, then slide the Battery out of
the Battery Slot.
WARNING: DO NOT try to remove the Battery without pressing the Battery Release button. The
tool or Battery could be damaged.

Fitting a battery

1. Fit a battery by sliding it on to the Battery Slot of the tool until it clicks and locks into position
Note:
Make sure the Battery and tool are lined up correctly.
If the Battery does not slide into the tool easily, do not
force it. Instead, slide the Battery out of the tool again,
check the top of Battery and the tool battery slot are
clean and undamaged and that the contacts are not bent

Setting up the battery charger

1. If fitted, remove any Battery (B)from the Battery Charger(A)
2. Insert the Battery Charger mains plug into a suitable mains socket
Note: The Green LED(2) on the Charger will always bright to indicate that the charger is ready to
charge the battery.
1 2
A
WARNING: Use this charger ONLY to charge the supplied battery or additional purchased
batteries that are specifically designed for this tool.
WARNING: The charger is designed for indoor use only, and MUST NOT be used in damp or wet
conditions.
Charging the battery
WARNING: Failure to follow the correct procedure when charging batteries will result in
permanent damage.
Note: Normal charging time is approximately 35minutes for a recently discharged 2.0Ah capacity
battery. However, if the Battery has been left in a discharged state for some time, it may take
additional time to charge.
1. Slide a fully or partially discharged Battery on to the Battery Charger .
Note: Make sure the Battery and Battery Charger are lined up correctly. If the Battery does not
slide on to the Battery Charger easily, don' t force it. Instead, remove the Battery, check the top
of Battery and the Battery Charger slot are clean and undamaged and that the contacts are not
bent.
B
- -
8
Press
Insert a
Battery