Download
Share
Print this page
  1. Manuals
  2. Brands
  3. atiz Manuals
  4. Scanner
  5. BookDrive Mark 2
  6. Setup

atiz BookDrive Mark 2 Setup

Hide thumbs

Advertisement

Quick Links

Download this manual
Set up BookDrive Mark 2 Lite
www.atiz.com/support

Advertisement

loading
Need help?

Need help?

Do you have a question about the BookDrive Mark 2 and is the answer not in the manual?

Questions and answers

Related Manuals for atiz BookDrive Mark 2

Summary of Contents for atiz BookDrive Mark 2

  • Page 1 Set up BookDrive Mark 2 Lite www.atiz.com/support...

  • Page 2: Safety Precautions

    Safety Precautions Place the machine on a level table to ensure proper working condition. Do not tilt the machine. The machine is not designed to be lifted. Do not lift or relocate the machine once it has been fully assembled. To relocate the machine, desired location.
  • Page 3 Getting to know your BookDrive Mark ll Lite LED Lighting Panel Roof Camera Mount Shade Pillar V- Platen V-Cradle Base...

  • Page 4: How To Assemble

    How to assemble There are 3 small boxes in Mark 2 Lite’s box. Take 1,2 and 3 out as shown below. Tips : Take (1) then (2) and (3) Take the left and the right arms out, then take the foam out from the arm.
  • Page 5 Lay down the box and take out the machine as shown below. Now put the machine back on its feet.
  • Page 6 Remove the foam Remove the beam (removing bolts (6) by using the included Hex wench). This piece is only used for support during transportation. Remove bolts (7)
  • Page 7 Loosen the bolts (8) and turn lever of LED (9) out then lift the LED up. Tighten the bolts. Screw the bolts (10) and (11).
  • Page 8 11. Take V- platen and cradle out. Take the arm from Box 1. Connect the left and the right arm to the pillar and screw the bolts.
  • Page 9 13. Install the roof and screw the bolts.
  • Page 10 Put the cradle as shown. Put the v- platen on the cradle and lock the v-platen with knobs on each side.
  • Page 11 16. Put the plate to the pillar and lock it with bolts.
  • Page 12 Install the switching holder. Lock the standby switch box with bolts.
  • Page 13 19. Install the switching power supply. 20. Collect the cable as shown below.
  • Page 14 Connect standby switch and switching power supply to LED box. Attach the top shade as shown. Collect the cloth of shade into the inside.
  • Page 15 Attach the back shade as shown. Attach the left shade to the left side and the rigth shade to the right side.
  • Page 16 26. Attach the front shade to the front. 27. Attach the inner shades to the front shade.
  • Page 17 28. Attach the camera shades to the left and right of roof.
  • Page 18 How to make image straight When the camera is not perfectly aligned resulting in a slightly rotated image, you can do micro adjustment at the plate where the camera is mounted. Your image should come out straight and look like this. If you image looks like A, then loosen the screws slightly and then adjust screws...
  • Page 19 How to install camera Auto Capture Switch...
  • Page 20 How to set up the platen parallel with the cradle 1. Loosen the bolts at the position A. 2. Adjust by turning the position B. 3. When the position is properly then lock the bolts at the positon A.
  • Page 21 @Copyright 2006-2017 Atiz Innovation Co.,Ltd. All rights reserved.