Advertisement
Quick Links
BenQ Lighting
LED Flat Panel Light FPLA2 – Installation Manual
PLEASE READ THESE INSTRUCTIONS CAREFULLY BEFORE INSTALLATION.
LEAVE A COPY FOR THE USER / MAINTENANCE ENGINEER FOR FUTURE REFERENCE
IMPORTANT INSTALLATION INFORMATION
Installation should be carried out in accordance with the latest edition of the
National Wiring Regulations. If in doubt, consult a qualified electrician.
Make sure the power is off before installation.
Input Voltage 100-240V~ AC
The luminaire is for indoor use only.
This luminaire is not suitable for covering with insulation material.
Insure that ALL electrical connections are tight with no loose strands.
INSTALLATION INSTRUCTIONS:Isolate the mains supply before servicing or installation
1
Remove the selected ceiling panel and an adjacent panel to allow for installation of the
LED Panel and LED Driver.
2
Ensure the clearances shown in Figure 1 are observed.
Beware of joists, water pipes and electric cables.
Figure 1
Minimum void depth 120mm
Bringing Enjoyment & Quality to life
50mm min clearance to joists...etc.
3
Install the driver on the back of the Flat Panel Light as shown in Figure 2
Figure 2
Connect LED wires to driver (OUTPUT) as shown in Figure 3-1
4
Two Red Wires connect to
insulation terminals.
Two Black Wires connect to
Connect AC power cable to Driver (INPUT) as shown in Figure 3-2
5
(a) White Wire connect to
N
insulation terminal.
(b) Black Wire connect to
insulation terminal.
L
Figure 3-1
RED
BLACK
RED
BLACK
insulation terminals.
Figure 3-2
L
N
Advertisement
Related Manuals for BenQ FPLA2
Summary of Contents for BenQ FPLA2
- Page 1 BenQ Lighting Install the driver on the back of the Flat Panel Light as shown in Figure 2 LED Flat Panel Light FPLA2 – Installation Manual PLEASE READ THESE INSTRUCTIONS CAREFULLY BEFORE INSTALLATION. Figure 2 LEAVE A COPY FOR THE USER / MAINTENANCE ENGINEER FOR FUTURE REFERENCE...
- Page 2 BenQ Lighting Recessed Mode Mount the driver to the back of the panel light as shown in Figure 4-1. Make sure the cabling is complete for luminaire to install on the ceiling as shown in Figure 6 Use the wire ring to tie the wires together before installing with the cover. (Figure 4-2) Screw and lock the two covers to the back of the Flat Panel Light.